14INITIALSETTINGS
Auto Set Up
Auto channel Set/Auto Clock Set/Auto Guide Channel Set
The Auto Set Up function sets the clock, tuner channels and Guide Channels automatically when the button on the recorder/remote is first pressed to power on the recorder after you plug the mains power cord into a mains outlet.
Before starting the following procedure, make sure that the TV aerial cable is connected to the recorder and that the recorder's mains power cord is connected to a mains outlet (☞ pg.10).
q |
CHAINE +/–
2
1 2 3
4 | 5 | 6 |
7 8 9
0 4
CHAINE +/–
3
1
| 1 |
| PERFORM AUTO SET UP | ||||
|
| Press |
|
|
| on the recorder or remote control. | |
|
|
| |||||
|
| "Auto" appears on the display panel and blinks; do | |||||
|
| NOT press any button on the recorder or remote | |||||
|
|
| control until the display panel shows the current | ||||
|
|
| time or "CH1" or | ||||
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
| ● Auto channel set function takes place first; it assigns | ||||
|
|
| automatically all receivable stations in your area so | ||||
|
|
| that you can call them up with the CHAINE buttons | ||||
|
|
| without going through any vacant channel. | ||||
|
|
| ● Auto clock set function sets the clock automatically | ||||
|
|
| by reading the clock setting data from a station | ||||
|
|
| transmitting a PDC signal while auto channel set is | ||||
|
|
| being performed. | ||||
|
|
| ● During auto channel set, the recorder recognizes each | ||||
|
|
| station name of the detected stations which transmit a | ||||
|
|
| PDC signal by reading the NI (= Network Identifica- | ||||
|
|
| tion) code, stores them in the recorder's memory, and | ||||
|
|
| then automatically sets SHOWVIEW assigned Guide | ||||
|
|
| Channel for those stations according to the broadcast | ||||
|
|
| area. Depending on the reception conditions, the | ||||
|
|
| station names may not be stored correctly, and auto | ||||
|
|
| Guide Channel set may not work properly; check if the | ||||
|
|
| Guide Channels have been set correctly (☞ pg.24, | ||||
|
|
| "SHOWVIEW Setup"). | ||||
|
|
|
|
|
|
|
|
NOTES:
●If the TV power is on and its AV mode is selected during Auto Set Up, the REG.AUTO.DES CANAUX screen will appear.
●If there is a power cut, or if you press or MENU while Auto Set Up is in progress, Auto Set Up will be interrupted; be
sure to turn off the recorder power once and press to turn the power back on to
●If the memory backup fails because there has been a power cut or the mains power has been removed from the recorder, since all the assigned tuner channels and their Guide Channels remain in the recorder's memory, the recorder will not perform
Auto Set Up even if you press to turn the recorder power back on. Simply perform clock set procedure (☞ pg. 22).
●When Auto Set Up has been completed successfully the correct current time will be displayed.
●When auto channel set has been completed successfully but auto clock set has not, "CH" will be displayed.
●When neither auto channel set nor auto clock set has been completed successfully,
* See "SHOWVIEW Setup" on page 24 to check if the Guide Channels have been set correctly.