JVC HR-J746MS Select Channel to FINE-TUNE, Access Manual CH. SET Screen, Perform Tuning

20INITIALSETTINGS(cont.)

Perform steps 1 and 2 of "Storing Channels Manually" on page 18 to access the Confirmation screen before continuing.

Fine-Tuning Channels Already Stored

SELECT CHANNEL TO

FINE-TUNE

1 Press MULTI-FONCTIONS%Þ% %until the channel you want to tune begins blinking.

ACCESS MANUAL CH. SET SCREEN

2 Press OK three times. The Manual Ch. Set screen appears.

PERFORM TUNING

3 Press MULTI-FONCTIONS%Þ until the picture is its clearest. Then press OK.

●The Confirmation screen appears.

●Repeat steps 1 through 3 as necessary.

CLOSE CONFIRMATION SCREEN

4 Press MENU.

Set Stations (A)

1		SELECT ITEM
		Press MULTI-FONCTIONS%Þ%%until the item you
		want begins blinking. Then press OK twice and the
	station’s name (ID) begins blinking.
2		SELECT NEW STATION
		Press MULTI-FONCTIONS%Þ until the new station’s
		name (ID) you want to store begins blinking.
		Registered station names (☞ pg. 21) appear as you
		press MULTI-FONCTIONS %Þ.
3		SWITCH STATIONS
		Press OK.
		● Repeat steps 1 through 3 as necessary.
		CLOSE CONFIRMATION
4		SCREEN
		Press MENU.

Set Stations (B)

NOTE:

First perform step 1 of the above procedure.

SELECT STATION NAME

CHARACTER

2 Press MULTI-FONCTIONS%and the first letter of the station name begins blinking.

ENTER NEW CHARACTER

3 Press MULTI-FONCTIONS%Þ to cycle through the characters (A–Z, 0–9, –, *, +, [ (space) ) and stop when the desired one is indicated, then press MULTI- FONCTIONS % to enter. Enter the remaining characters the same way (maximum of 4).

After entering all characters, press OK.

● Repeat steps 1 through 3 as necessary.

● If you make a mistake, press MULTI-FONCTIONS% until the incorrect character begins blinking. Then enter the correct character by pressing MULTI-

FONCTIONS %Þ.

CLOSE CONFIRMATION SCREEN

4 Press MENU.