JVC HR-J449MS, HR-J746MS instruction manual Number, Close Menu, When Using a Satellite Receiver

ENTER SHOWVIEW NUMBER

	Press OK, and a cursor
	appears above “NUMERO	123455
4 GUIDE”. Then, using the
	NUMBER keys, input the		NUMERO GUIDE		CHAINE
	SHOWVIEW number (found			REGL. DES NUMEROS
	in most TV listings) of a	GUIDE 1			1
	program scheduled to be
	broadcast on each station
			[0–9] =
	on the list from step 1,		[MENU] : SORTIE
	starting at the top. If you		When entering a SHOWVIEW
	enter the wrong number,
			number for FR2
	press ANNUL. to backspace
	and input the correct number.
	CONFIRM PRESET POSITION
	NUMBER
4	Press OK and the display
	under “CHAINE” begins
5 blinking.			NUMERO GUIDE		CHAINE
	If the blinking number
	under “CHAINE” agrees
				2	2
	with the preset position . . .
	. . . press OK.
	If the numbers do not		[5°] =
	agree . . .		[MENU] : SORTIE
	. . . input the correct preset position using MULTI-
	FONCTIONS %Þ or the NUMBER keys, then press OK.

●If you input the SHOWVIEW number of a program that has already aired, “ERREUR” appears on screen for a few seconds. Input the correct SHOWVIEW number.

●Repeat steps 4 and 5 as necessary.

CLOSE MENU

6 Press MENU and selection is complete.

If you already know the Guide Channel for a station . . .

1– After step 3, press MULTI-FONCTIONS %.

●The NUMERO GUIDE number begins blinking.

2– Enter the Guide Channel using the NUMBER keys or MULTI- FONCTIONS %Þ, then press MULTI-FONCTIONS%.

●The CHAINE number begins blinking.

3– Enter the preset position using the NUMBER keys or MULTI- FONCTIONS %Þ, then press MULTI-FONCTIONS% .

●Repeat 2 and 3 as necessary. 4– Press PROG./MENU.

25

When Using A Satellite

Receiver

Satellite Antenna Aerial or Cable (*)

Satellite

Receiver

AV2 IN/DECODER

TV Receiver

Preparation

1– Connect the satellite receiver to the AV2 ENTREE/ DECODEUR connector on the rear of your recorder.

2– Set "SELECTION AV2" to "AUX" (☞ pg. 49).

To Record Satellite Broadcasts . . .

1– Select the appropriate channel on the satellite receiver. 2– Press NUMBER key "0" and/or CHAINE +/– to set your

recorder's input mode to "AUX2".

3– Start recording (☞ pg. 35, steps 3 – 6).

To Record Satellite Broadcasts Using SHOWVIEW Timer Recording . . .

1– Perform Guide Channel setting.

●In step 5 in the left column, press NUMBER key "0" and/or CHAINE +/– to set "CHAINE" to "AUX2".

2– Perform SHOWVIEW Timer Recording (☞ pg. 42).

To Record Satellite Broadcasts Using Regular Timer Recording . . .

1– In step 6 on page 45, press CHAINE +/– to set the channel position to "AUX2".

NOTES:

●When timer-recording a satellite programme, first set the satellite receiver to the appropriate channel before the selected programme begins and then set the satellite receiver's timer. If your satellite receiver does not have a timer, leave it switched on.

●(*) In some areas, cable network is provided through a cable box connected to the recorder via the 21-pin connector. In this case, perform the same procedure as for a satellite receiver.