JVC HR-S7700EK Safety Precautions, Connection to the mains supply in the United Kingdom

Page 2

2

SAFETYFIRST

Safety Precautions

The rating plate and the safety caution are on the rear of the unit.

WARNING: DANGEROUS VOLTAGE INSIDE

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.

IMPORTANT

■Please read the various precautions on page 2 – 4 of this instruction manual before installing or operating the recorder.

■It should be noted that it may be unlawful to re-record pre-recorded tapes, records, or discs without the consent of the owner of copyright in the sound or video recording, broadcast or cable programme and in any literary, dramatic, musical, or artistic work embodied therein.

IMPORTANT

Connection to the mains supply in the United Kingdom.

DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain a proper safety approved extension lead/ adapter or consult your dealer.

In the unlikely event of the plug fuse failing be sure to replace the fuse only with an identical approved type, as originally fitted, and to replace the fuse cover. If the fuse fails again consult your nearest JVC dealer.

If nonetheless the mains plug is cut off remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply.

If this product is not supplied fitted with a mains plug then follow the instructions given below: DO NOT make any connection to the Larger Terminal coded E or Green.

The wires in the mains lead are coloured in accordance with the following code:

Blue to N (Neutral) or Black

Brown to L (Live) or Red

If these colours do not correspond with the terminal identifications of your plug, connect as follows: Blue wire to terminal coded N (Neutral) or coloured Black.

Brown wire to terminal coded L (Live) or coloured Red.

If in doubt — consult a competent electrician.

625

■Cassettes marked "S-VHS" and "VHS" can be used with this video cassette recorder. However, S-VHS recordings are possible only with cassettes marked "S-VHS".

By using the S-VHS ET function, it is possible to record and play back with S-VHS picture quality on VHS cassettes with this recorder.

■VIDEO Plus+ and PlusCode are registered trademarks of Gemstar Development Corporation. The VIDEO Plus+ system is manufac- tured under license from Gemstar Development Corporation.

Page 1 Page 3
Image 2
Page 1 Page 3
Contents HR-S7700EK HR-S7722EK Safety Precautions Connection to the mains supply in the United KingdomMoisture Condensation Do not place the recorderSome Dos And Donts On The Safe Use Of Equipment Quick SET UP Guide Back of Recorder To connect to a TV with 21-pin AV input connector ScartBack of TV Mains outlet Mains Power Cord Video ConnectionRefer to With the AV or S-VIDEO connection Before performing the following procedure, make sure thatAuto for Auto Set Up function Tion pg and the TV is turned on,Progress, this process will be interrupted Or remote control until the display panelShows either the display as illustrated on You will need to start again. See Notes belowIf auto channel set has succeeded but auto clock set has not If both auto channel set and auto clock set have failedTurn on the Recorder TV Auto Power OnLink Functions NexTView LinkSatellite Receiver Control Setting Check Result of Test Select Satellite RECEIVER’S Channel for TestingEnter Satellite RECEIVER’S Brand Channel positionFind Programme Start Point PlaybackLoad a Cassette Start PlaybackPause During Playback Activate HIGH-SPEED SearchRecording Engage ITR Mode Select Preset to WatchReset Counter SET Counter DisplayAccess Video PLUS+ Program Screen Video Plus+ Timer ProgrammingAccess Video PLUS+ Screen Enter Pluscode NumberTimer Warning PDC RecordingTime Express Timer ProgrammingBefore performing Express Timer Programming Enter Programme DateReturn to Normal SET PDC ModeTimer Mode Engage RECORDER’SCancel or Replace a Programme Check, Cancel And Replace ProgrammesAccess Programme SCREEN/ Display Return to Timer ModeTo cancel a programme When programmes overlap each otherCancel or Change Programme Setting Confirm Overlapping ProgrammesManual Tracking Playback Picture AdjustmentDigital TBC/NR Digital 3RSoundtrack Selection Selecting Sound You WantReceiving Nicam Stereo And Bilingual Programmes During PlaybackActivate Instant Review Looking For Scene You WantActivate Index Search Skip Over UnwantedRecording According To Tape Type Super VHS S-VHS VHS ET and VHSPlayback/ Recording According To Tape Charac- teristics S.T. Picture SystemOr press Record on the recorder RecordingPlayback Satellite Receiver Unit Connector TV Aerial cable Audio in connectorAutomatic Satellite Programme Recording AerialScreen Select L-2 Select ModeREC Mode Engage Auto Satellite ProgSelect Picture Control SET Mode Access Main Menu ScreenAccess Mode SET Screen Minimizing Picture Degradation While EditingMake Connections SET RECORDER’S Input ModeSET Edit Mode Start CamcorderEdit To Or From Another Video Recorder Input ModeSET Edit Mode SET Recording DECK’SRecorder Player OUTPUT/INPUT Setting SELECT/INPUT SettingEngage Audio Dubbing SET Input ModeLocate Start Point Start DubbingLocate END Point Reset the CounterInsert Editing END Insert Editing Engage Insert EditingStart Editing On-Screen Display ENABLE/DISABLE ON-SCREEN DisplayOther Functions Next Function Memory Power Save ModeAuto Timer SET, then press OK or # Auto SP→LP TimerFor Example Then press OK or #to selectRepeat Playback Engage RECORD-PAUSE ModeResume Recording Ntsc PlaybackConnection To Stereo System Speaker Television Mains outletGuide Program Number Set Video Plus+ SetupNumber Video Channel Set Access Video Channel SET ModeExit Video Channel SET Mode SET Video ChannelWith RF Connection Auto Channel Set Tuner SetPerform Auto Channel SET After Scan Completed Screen preset positionsProcedures Is displayed on the screenInput Channel Storing Channels ManuallySelect Band Enter NEW Channel InformationFine-Tuning Channels Already Stored When Receiving a Scrambled BroadcastChange Station Preset Position Delete a ChannelChannel SET Screen Access ManualSwitch Stations Select NEW StationTV Station And ID List TV Station Channel Number Guide Clock Set Just ClockWhat happens if the tape runs out during recording? Questions And AnswersÄ remain lit on the display panel. Is there Problem? Troubleshooting Ejected, and ä and on Record Safety tab removed Subsidi ARY InformationIndex Front ViewRear View Display Panel Remote Control Timer Button engages timer-standby mode. pg VCR, TV PR +/-,TV +/-, TV MutingMaximum recording time DA4 Double Azimuth helical
Top Page Image Contents