62 EN |
| TROUBLESHOOTING (cont.) | |
RECORDING |
|
| |
| SYMPTOM | POSSIBLE CAUSE | CORRECTIVE ACTION |
1. | Recording cannot be started. | ● There is no cassette loaded, or the | Insert a cassette, or using adhesive tape, |
|
| cassette loaded has had its record safety | cover the hole where the tab was |
|
| tab removed. | removed. |
|
|
|
|
2. | TV broadcasts cannot be recorded. | ● | Set to the desired channel. |
|
| been selected as the input mode. |
|
|
|
|
|
3. | ● The source (another video recorder, | Confirm that the source is properly | |
|
| camcorder) has not been properly | connected. |
|
| connected. |
|
|
| ● All necessary power switches have not | Confirm that all units’ power switches are |
|
| been turned on. | turned on. |
|
| ● The input mode is not correct. | Set the input mode to |
|
|
| or |
|
|
|
|
4. | Camcorder recording is not possible. | ● The camcorder has not been properly | Confirm that the camcorder is properly |
|
| connected. | connected. |
|
| ● The input mode is not correct. | Set the input mode to |
|
|
| or |
|
|
|
|
5. | “[” on the front display panel won’t | ● The end of the tape was reached during | The programme may not have been |
| stop blinking. | recording. | recorded in its entirety. Next time make |
|
|
| sure you have enough time on the tape to |
|
|
| record the entire programme. |
|
|
| |
TIMER RECORDING |
|
| |
| SYMPTOM | POSSIBLE CAUSE | CORRECTIVE ACTION |
1. | Timer recording won’t work. | ● The clock and/or the timer have been set | |
|
| incorrectly. | settings. |
|
| ● The timer is not engaged. | Press # and confirm that “#” is displayed |
|
|
| on the front display panel. |
|
|
|
|
2. | Timer programming is not possible. | ● Timer recording is in progress. | Timer programming can’t be performed |
|
|
| while a timer recording is in progress. |
|
|
| Wait until it finishes. |
|
|
|
|
3. | “#” and “[” on the front display | ● The timer is engaged but there’s no | Load a cassette with the record safety tab |
| panel won’t stop blinking. | cassette loaded. | intact, or cover the hole using adhesive |
|
|
| tape. |
|
| ● The loaded cassette has had its record | Remove the cassette and cover the hole |
|
| safety tab removed. | with adhesive tape, or insert a cassette |
|
|
| with the record safety tab intact. |
|
| ● The end of the tape was reached during | The programme may not have been |
|
| timer recording. | recorded in its entirety. Next time make |
|
|
| sure you have enough time on the tape to |
|
|
| record the entire programme. |
|
|
|
|
4. | “#” blinks for 10 seconds and the | ● # has been pressed when there are no | Check the programmed data and re- |
| Timer mode is disengaged. | programs in memory, or the timer | program as necessary, then press # again. |
|
| record information has been |
|
|
| programmed incorrectly. |
|
|
|
|
|
5. | The SHOWVIEW system does not | ● The recorder’s channel positions have | Refer to “Guide Program Number Set” |
| been set incorrectly. | ( pg. 51) and | |
|
|
|
|