INSTALLING YOUR NEW RECORDER | EN 9 |
Basic Connections
Aerial connector
Back of TV
TV aerial | |
connector | cable |
| |
cable | RF cable |
(not provided) | |
| (provided) |
Mains power cord | ANT. IN |
Back of recorder
AV1
Mains outlet
Make AV connection if your TV has a
NOTES:
●The AV1
●Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to the type of your TV’s SCART connector.
●For switching the TV’s mode, refer to the instruction manual of your television.
It’s essential that your video recorder be properly connected.
THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.
A Check the contents.
Make sure the package contains all of the accessories listed in “SPECIFICATIONS” on page 65.
B Situate the recorder.
Place the recorder on a stable, horizontal surface.
C Connect the recorder to TV.
The connection method you use depends on the type of TV you have.
RF Connection
8To connect to a TV with NO AV input connectors . . .
ADisconnect the TV aerial cable from the TV.
BConnect the TV aerial cable to the ANT. IN connector on the rear panel of the recorder.
CConnect the provided RF cable between the RF OUT connector on the rear panel of the recorder and the TV’s aerial connector.
AV Connection
8To connect to a TV with AV input connectors . . .
AConnect the aerial, recorder and TV as per “RF Connection”.
BConnect an optional
D Connect the recorder to mains.
Plug the end of the mains power cord into a mains outlet.
After the connection is completed, perform “Auto Set Up” on page 10.