JVC HR-S7600U manual Edit To Or From Another

EDITING

EN55

You can use your VCR as the player or the recorder.

Edit To Or

From Another

VCR

Player	AUDIO OUT
	Your VCR

CABLE		IN	OUT		ANTENNA	IN
BOX
S VIDEO				REMOTE	AV	VHF/UHF
IN	OUT		L	PAUSE	COMPULINK
		(MONO)			TV	OUT
			VIDEO		CH3
					CH4

S VIDEO OUT
	VIDEO
	OUT
S-Video cable	Audio/Video cable
(supplied)	(supplied)
S VIDEO IN	AUDIO IN

Recorder VIDEO IN Another VCR

Advantages Of S-VHS Editing

S-VHS allows you make high resolution video recordings when dubbing from one VCR to another.

You can edit from VHS to S-VHS, from S-VHS to VHS, or from S-VHS to S-VHS.

●From VHS to S-VHS (VIDEO-VIDEO connection): Record VHS playback signals in the S-VHS mode. Although the picture quality is inherently limited by the orignal VHS source material, the edited tape has better picture quality than those made by VHS-to-VHS editing.

●From S-VHS to VHS (VIDEO-VIDEO connection): Because the picture quality of the source material is very high, the edited tape has better picture quality than those made by VHS-to-VHS editing.

●From S-VHS to S-VHS (S-VIDEO connection): A high resolution copy is made of a high resolution original S- VHS tape with minimal picture degradation. This is the preferred method of video dubbing.

1	MAKE CONNECTIONS
	Connect an AV cable between the player’s VIDEO OUT
	and AUDIO OUT connectors and the recorder’s VIDEO
	IN and AUDIO IN connectors.
	● If using another VCR with an S-VIDEO input or
	output connector, it is recommended to use the S-
	VIDEO connection to minimize picture degradation
	while editing.
	● When using your VCR as the recorder and a monaural
	VCR as the player, connect the player’s AUDIO OUT
	connector to the AUDIO IN L connector on the recorder.
2	LOAD CASSETTES
	Insert the playback cassette into the player and the
	cassette to be recorded on into the recorder.
	SET RECORDER’S INPUT
3	MODE
	Set to "AUX". With this VCR, press the NUMBER key "0"
	and/or CH to select depending on the connector being
	used – "L-1" for the rear AUDIO/VIDEO IN connector,
	or "F-1" for the front AUDIO/VIDEO IN connector.
	NOTE:
	If you use your VCR as the recorder and have connected
	another VCR to your VCR's S-VIDEO IN connector, you
	need to set "REAR AUX INPUT" to "S-VIDEO" at the
	Function screen. Follow steps 4 – 6 from the "Edit From
	A Camcorder" section (☞ pg. 56).
4	START PLAYER
	Set to its play mode.
	NOTE:
	If the player is equipped with a superimpose/OSD
	disable feature then set "SUPERIMPOSE" to OFF before
	pressing PLAY (☞ pg. 29).
5	START RECORDER
	Set to its record mode.

NOTES:

●If you use an auxiliary input to connect a cable box or DBS receiver, make sure that the correct AUX INPUT ("VIDEO" or "S-VIDEO") is selected after you have finished editing (☞ step 4 – 6, page 56 ).

HR-S7600U-EN45-64 55 99.4.28, 2:05 PM