JVC HR-S9500E Basic Connections, Check Contents, Situate Recorder, Connect Recorder to Mains

4EN

INSTALLINGYOURNEWRECORDER

Basic Connections

Aerial terminal

Back of TV

21-pin SCART

connector

TV Aerial

Cable

RF Cable (provided)

21-pin SCART Cable

Mains Power Cord

		Back of
	AV1 OUT switch
		Recorder
Mains outlet		AV1 IN/OUT

It's essential that your video recorder be properly connected. Follow these steps carefully. THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.

		CHECK CONTENTS
	Make sure the package contains all of the accessories
1 listed in “Specifications” (☞ pg. 66).
		SITUATE RECORDER
2 Place the recorder on a stable, horizontal surface.
		CONNECT RECORDER TO
3		TV
	The connection method you use depends on the type of
		TV you have.
		RF CONNECTION
		● To Connect To A TV With NO AV Input Terminals . . .
		a– Disconnect the TV aerial cable from the TV.
		b– Connect the TV aerial cable to the ANT. IN jack
		on the rear panel of the recorder.
		c– Connect the provided RF cable between the RF
		OUT jack on the rear panel of the recorder and the
		TV’s aerial terminal.

AV CONNECTION

●To Connect To A TV With AV Input Terminals . . .

a– Connect the aerial, recorder and TV as per “RF

CONNECTION”.

b– Connect an optional SCART cable between the

AV1 IN/OUT socket on the rear panel of the recorder and the TV’s 21-pin SCART connector.

c– Set the AV1 OUT switch to the appropriate position. See "AV1 OUTPUT SIGNAL SELECTION FOR AV CONNECTION" below.

CONNECT RECORDER TO MAINS

4 Plug the end of the mains power cord into a mains outlet.

Make AV connection if your TV has a 21-pin AV input connector (SCART) in order to reduce the possibility of interference. And if you are using a stereo TV, you will need this cable in order to enjoy stereo playback of videotapes.

After you plug the mains power cord into a mains outlet, the Country Set display appears on the TV screen and/or on the

recorder's front display panel when the button on the recorder/remote control is pressed for the first time to power on the recorder; go to page 6 to perform Auto Set Up.

AV1 OUTPUT SIGNAL SELECTION FOR AV CONNECTION

The AV1 IN/OUT connector accepts only a composite signal (regular video signal), but can deliver either a composite video signal or a Y/C signal (a signal in which the luminance and chrominance signals are separated) according to the setting of the rear panel AV1 OUT switch.

●If your TV's 21-pin AV input connector (SCART) is compatible only with the regular video signal, set this switch to COMP.

●If your TV's 21-pin AV input connector (SCART) is compatible with the Y/C signal, set this switch to Y/C. You can obtain high- quality S-VHS pictures. (For connection, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.)

NOTES:

●Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to the type of your TV's SCART connector.

●For switching the TV's mode, refer to the instruction manual of your television.

●To obtain high-quality S-VHS pictures, you can also use the S-VIDEO CONNECTION described on page 5.