JVC SR-9240EK appendix Troubleshooting, Error Indication, Error Contents VCR operation Measures

9 TROUBLESHOOTING

9-1 Error Indication

Error indications are shown on the display whenever there are problems with cassette loading, unloading or mechanism operation.

5When a problem occurs, the error indication E- – – blinks.

5When any one of the error indications is shown, a 12 V warning signal is output from the rear panel's WARNING OUT connector (for E-01 to E07, and E-11 during recording) (only when the <TERMINAL SEL 2> menu function switch is set to "WARN").

5When the function menu switch <WARNING BUZZER> is set to ON, the buzzer sounds whenever a problem occurs (for E-01 to E07, and E-11 during recording).

When an error indication appears or the buzzer sounds, turn the operating mode off and then on again to clear the error indication and buzzer sound.

When the error indication E- – – is shown, turning the operating mode on again may not clear the problem. In this case, consult your local JVC dealer (for E-01 to E- 07).

Display section

TIME MODE

	Error indication
	VTR MODE 1
	(SHARPNESS)	NORMAL
	(VIDEO MODE)	AUTO
	(AUTO REC)	OFF
	(REC CHECK)	MANUAL
	(TAPE END MODE)	REPEAT
	(INDEX SEARCH)	OFF
	(CAMERA SW)	OFF
Buzzer sound	(TAPE END BUZZER)	OFF
	(WARNING BUZZER)	ON

PRESS (SHIFT, SET)

PRESS (MENU) TO END

VTR mode 1 setting screen

Error	Contents	VCR operation	Measures
indication
E-01	Problem with loading operation	The operating mode is turned off.	Turn the operating mode on again.
E-02	Problem with unloading operation	The operating mode is turned off.	Turn the operating mode on again.
E-03	Problem with supply reel rotation	The operating mode is turned off.	Turn the operating mode on again.
E-04	Problem with drum rotation	The operating mode is turned off.	Turn the operating mode on again.
E-05	Problem with take-up reel rotation	The operating mode is turned off.	Turn the operating mode on again.
E-06	Problem with capstan rotation	The operating mode is turned off.	Turn the operating mode on again.
E-07	Problem with eject operation	The operating mode is turned off.	Turn the operating mode on again.
E-09	Error with recording check	Cleans the heads with the VCR's	Cleans the heads with the head
	(inferior recording performance)	head cleaner.	cleaning tape, then check the
			recording picture quality again. The
			tape may be defective. Replace the
			tape and check again.
			If the picture quality is still inferior,
			consult your local JVC dealer.
E-10	Insufficient capacity of the built-in	—	Contact your local JVC dealer to
	battery for backup (Displayed		replace the built-in battery.
	only in the operating off mode.)
E-11	No video signals input to the	—	Input video signals.
	[VIDEO IN] connector

This unit uses a microprocessor and may not function properly if there is external noise or interference. In this case, turn the operating mode off and unplug the power cord from the AC outlet. Then plug the power cord in again and check operation.

			43
→		For servicing
	See page 1-10 “1.7 WARNING DETECTION CIRCUIT”