JVC SR-9240EK appendix Installation of the SA-K97U, Top cover

10. OPTIONAL SA-K97U RS-232C INTERFACE BOARD

Functions that can be controlled with front panel buttons and switches can also be controlled from a personal computer when the optional SA-K97U RS-232C interface board is installed. Operation status can also be monitored on the computer.

10-1. Installation of the SA-K97U

Rear panel

MIC VIDEO	AUDIO
IN
IN	IN	SA-K97U
REMOTE		installation
	OUT	section
OUT

Top cover

Screws

Plate

	SA-K97U
Positioning	RS-232C board	Projection sections
holes
		(2 positions)
(2 positions)
		Screws (2)

The procedure is shown below. However, to avoid electric shock or injury, contact your local JVC service center for details.

Note:

When installing this board, be careful not to injure yourself on sharp edges and metal parts inside the VCR.

Before installing the board, turn the power off and unplug the power cord from an AC outlet.

1. Detach the top cover.

Remove the 5 screws securing the top cover and lift it off.

2. Detach the plate in the VCR.

Remove the 2 screws on the rear panel. Detach the plate from the inside of the VCR.

3. Connect the SA-K97U’s connector to the VCR.

Insert the SA-K97U connector into the connector (CN607) on the board in the VCR using a tool such as a pincette.

•During insertion, make sure the connector is aligned properly.

•Press both edges of the connector to insert it securely.

4.Install the SA-K97U in the VCR.

Make sure the SA-K97U bracket is facing the correct direction and align the positioning holes on the bracket with the projections (2 positions) on the VCR’s case. Secure the bracket with the 2 screws removed in step 2.

5. Attach the top cover as before.

Attach the top cover to the VCR using the 5 screws removed in step 1.

Make sure you use the correct screws.

VIDEO AUDIO

ININ

OUT

OUT

SA-K97U

45