JVC Model HR-J660EK Video Channel Set, Access Video CHAN- NEL SET Mode, SET Video Channel

30SUBSIDIARYSETTINGS

Video Channel Set

Video Channel (RF Output Channel) is the channel on which your TV receives picture and sound signals from the video recorder through the RF cable.

DISPLAY

STANDBY/ON

	TIMER
VIDEO(MONO)L –AUDIO– R	REC LINK	TV PROG

STOP

IMPORTANT

Perform the following steps only if —

—Video Channel Set has not been done correctly by the Auto Set Up function (☞ pg. 6).

—interference appears in the TV picture after you have moved to a different area or a new station has started broadcasting in your area.

—you change the connection between your recorder and TV from RF connection to AV connection, or vice versa.

●If you have connected the video recorder to your TV via both an RF cable and a 21-pin SCART cable (AV connection), you do not need the video channel so you have to set the video channel to off. — Go to "With AV Connection" below.

●If you have connected the video recorder to your TV via an RF cable only (RF connection), you have to set the correct video channel — Go to "With RF Connection" on page 31.

With AV Connection

Before performing the following procedure, make sure that:

■the mains power cord is plugged into the mains outlet.

■the video recorder is turned off and there is no cassette inserted in the recorder.

■batteries have been installed in the remote control.

1 2 3

4 5 6

7 8 9

0

2

4

TV PROG

ACCESS VIDEO CHAN- NEL SET MODE

Press and hold down STOP on the recorder until the

1 display panel shows the following.

SET VIDEO CHANNEL

Press TV PROG – until the display panel shows

1 ?

OK

2 "–OUT– –".

●Now the video channel is set to off.

EXIT VIDEO CHANNEL SET MODE

3 Press OK.

To view picture signals from the video recorder, set your TV to its AV mode. Refer to the instructions supplied with your TV set for how to do this.