JVC HM-DH5U manual 68 EN, Vhs Et, Display, Lighting

Filename [HM-DH5U_Eng.fm]

HM-DH5U_Eng.fm Page 68 Tuesday, June 1, 2004 4:16 PM Masterpage:Left-FullCol

68 EN	OTHER USEFUL FUNCTIONS (cont.)
	*The default setting is bold in the table below.
L “S-VHS ET”	This function allows you to record on VHS tapes with S-VHS picture quality. Tapes
“ON”	recorded using this function can be played back on a VCR equipped with the S-VHS ET
“OFF”	function. The [S-VHS] indicator on the front display panel lights up when “S-VHS ET” is
	set to “ON”.
	NOTES:
	• Before recording, make sure that “V. CALIBRATION” is set to “ON” (A page 63).
	• You cannot activate the S-VHS ET function...
	- while recording is in progress.
	- while timer-recording or Instant Timer Recording (A page 37) is in progress.
	- while Video Calibration (A page 63) is in progress.
	• S-VHS ET does not work with S-VHS tapes.
	• To keep the highest quality recording and playback pictures over a long period of time, S-VHS
	recording on S-VHS tapes is recommended.
	• Use of high grade tapes are recommended for S-VHS ET recordings.
	• On some tapes, picture quality will not improve even if the S-VHS ET function is used. Check the
	recording quality before you start important recordings.
	• You can play back S-VHS ET recordings on most of S-VHS VCRs and of VHS VCR equipped with
	SQPB (S-VHS QUASI PLAYBACK) function. (Notice some VCRs are not compatible with this
	function.)
	• While playing back a tape recorded with this function on some tapes, noise may appear. (If
	playback picture becomes blurred or interrupted, use a cleaning cassette.)
	• During special effect playback (A page 33), noise may appear. If special effect playback is
	performed frequently on a tape recorded with this function, the tape may be damaged and
	picture may be deteriorated.
L “DISPLAY”	When this function is set to “OFF”, only [:] appears on the front display panel.
“ON”	NOTE:
“OFF”
	Even if you set “DISPLAY” to “OFF”, each item appears on the front display panel in the
	following cases;
	• when the timer-recording is in progress/in the timer standby mode (A page 40 - 50).
	• in the satellite Auto Recording standby mode (A page 47).
	• during Plug & Play setting (A page 16).
	• when you press [REC (R)] twice for the ITR (A page 37).
	• when you set the remote control code (A page 78).
	• when you press [DISPLAY], the current status appears for a few seconds.
L “LIGHTING”	This function allows you to turn on/off the blue LED on the front panel.
“AUTO”
“OFF”