JVC HM-DH5U manual 26 EN, Setting DBS receiver input channel & brand, Turn on DBS receiver

Filename [HM-DH5U_Eng.fm]

HM-DH5U_Eng.fm Page 26 Tuesday, June 1, 2004 4:09 PM Masterpage:Left-FullCol

26 EN INITIAL SETTING (cont.)

•Turn on the VCR and the TV, and select the AV mode on the TV.

•Set the [VCR/TV/CABLE/DBS] selector on the Remote to [VCR].

Setting DBS receiver input channel & brand

After installation, set the DBS receiver’s input channel and its brand correctly; otherwise, the Controller cannot work correctly.

VCR CABLE TV /DBS

A Turn on DBS receiver

Select a channel other than channel 100 or 205 on your DBS receiver.

B C

Access Main Menu screen on VCR

Press [MENU].

Access DBS Receiver Set screen

B

C D

APress [D E] to move the arrow to “TUNER SET UP”, then press [G] or [OK].

BPress [D E] to move the arrow to “DBS SET UP”, then press [G] or [OK]

FUNCTION SET UP	TUNER SET UP		INITIAL SET UP
TUNER SET		CABLE SET UP		DBS SET UP
INPUT CH				OFF
BRAND				40
TEST MODE
MENU	OK	SELECT WITH ARROW KEYS
EXIT	SELECT	THEN PRESS [OK]

D

Select DBS receiver input chan- nel

Press [FG] to move the arrow to “INPUT CH”.

Your selection depends on how your DBS receiver is connected to your VCR.

FUNCTION SET UP	TUNER SET UP		INITIAL SET UP
DBS SET UP
INPUT CH			OFF
BRAND			40
TEST MODE
MENU	OK	SELECT WITH ARROW KEYS
EXIT	SELECT	THEN PRESS [OK]

•If your DBS receiver is connected to your VCR’s [ANTENNA IN] terminal on the rear panel

Press [D E] until the channel number representing the DBS receiver’s output (“ON CH3” or “ON CH4”) appears on the screen.

•If your DBS receiver is connected to your VCR’s [AUDIO/VIDEO] input connectors on the front panel

Press [D E] until “ON F-1” appears on the screen.

•If your DBS receiver is connected to your VCR’s [AUDIO/VIDEO INPUT (L-1)] or [AUDIO/VIDEO INPUT (L-2)] connectors on the rear panel

Press [D E] until “ON L-1” or “ON L-2” appears on the screen.

•If you do not use a DBS receiver

Press [D E] until “OFF” appears on the screen.