19
To program using the brand search:
1.Press the DEVICE/INPUT button where you wish to program this component’s codes (AUD, CD, TUN, TAPE and
2.Press the SETUP button (the LCD displays SET- UP). Press the ENT button to confirm.
3.Press the UP/DOWN cursor buttons until SET- UP BRAND appears in the display. Press the ENT button to confirm.
4.Press the UP/DOWN cursor buttons until the type of component you are searching for ap- pears in the display (TV, VCR, SAT, CTV, DVD, CD, etc.) Press the ENT button to confirm. The
first available brand starting with the letter A appears in the display.
5.Select the first letter of your component’s brand, using the +/– cursor buttons. Then, use the UP/DOWN cursor buttons to scroll through the list until the desired brand appears. Press ENT to confirm.
6.The brand along with the first available
7.Press any COMMAND button to test the first available code for your brand. For example, if you are testing a code for a TV, you could press the CH UP button to confirm that the channel changes on the TV. The
If the command button operates the component, you have found a code that may work. You can test additional commands by pressing more COMMAND keys. If success- ful, press the ENT button to save the code.
If the command button does not work, press the UP cursor button again to test the next code for that brand, with the new 4- digit code being tested shown in the display. Continue testing codes until you find one that works, saving it by pressing the ENT button.
8.Press the SETUP button at any time to exit the programming mode.