Programming by Auto-Search

To search for a code from the full list of available

4-digit codes for a type of component:

1.Press the DEVICE/INPUT button where you wish to program this component’s codes (AUD, CD, TUN, TAPE and V1–V5).

2.Press the SETUP button (the LCD displays SET- UP). Press the ENT button to conﬁrm.

3.Press the UP/DOWN cursor buttons until SET- UP A. SEARCH appears in the display. Press the ENT button to conﬁrm.

4.Press the UP/DOWN cursor buttons until the type of component you are searching for ap- pears in the display (TV, VCR, SAT, CTV, DVD, CD, etc.) Press the ENT button to conﬁrm.

5.Press and release the POWER ON button to advance to the next code.

6.Test the code by pressing any COMMAND buttons suitable for that component. For ex- ample, if testing a CD player, press the PLAY button.

If the commands work for the desired component, you have found a code that may work. If successful, press the DEVICE/INPUT button to save the code.

If the commands do not work, press and release the POWER ON button again to advance to the next available code for that component, with the new 4-digit code being tested shown in the display. Continue pressing the POWER ON button and testing codes un- til you have found a code that works, saving it by pressing the DEVICE/INPUT button.

7.Press the SETUP button at any time to exit the programming mode.

NOTE: You can return to the previous 4-digit code by pressing the MUTE command button.