Rotel RR-1060 manual Editing DEVICE/INPUT button labels, Editing Command button labels

28RR-1060

Editing DEVICE/INPUT button labels

To change the label for a button, make sure that you have selected the Page 2 set of labels (see above), then:

1.Press the SETUP button.

2.Press the UP/DOWN cursor buttons until EDIT appears in the display. Press the ENT button to confirm.

3.Press the UP/DOWN cursor buttons until EDIT DEVICE appears in the display. Press the ENT button to confirm.

4.Press the DEVICE/INPUT button (AUD, CD, TUN, TAPE, EXT, V1–V5)that you wish to re- label. The current label appears on the sec- ond line of the display.

5.Press the +/– buttons to select a letter in the label to change and the UP/DOWN cursor buttons to change the letter. The Character Map illustration shows the available charac- ters. Labels can be up to 8 characters.

6.When the new label is complete, press the SETUP button to save the new label.

7.A confirmation message appears in the LCD. Use the UP/DOWN buttons to select either YES (to confirm the new label) or NO (to exit without making any changes). Press the ENT button to confirm the selection.

Editing COMMAND button labels

To change the label for a button, make sure that you have selected the Page 2 set of labels, then:

1.Press the DEVICE/INPUT button (AUD, CD, TUN, TAPE, V1–V5)containing the COM- MAND button you wish to relabel.

2.Press the SETUP button.

3.Press the UP/DOWN cursor buttons until EDIT appears in the display. Press the ENT button to confirm.

4.Press the UP/DOWN cursor buttons until EDIT KEY appears in the display. Press the ENT but- ton to confirm.