Multi-Tech Systems MT5600SMI-P32 Commands and Parameters, Mode Entry Commands, Mode Commands

Chapter 6 – Fax Class 1 and Class 1.0 Commands

Commands and Parameters

Mode Entry Commands

+FCLASS=1 Select Facsimile Class 1 Mode

+FCLASS=1 selects the Fax Class 1 Mode. The Fax Class 1 Mode commands and responses described in this section are applicable when command +FCLASS=1 as shown in Table 6-1.

+FCLASS=1.0 - Select Facsimile Class 1.0 Mode

+FCLASS=1.0 selects the Fax Class 1.0. The Fax Class 1.0 Mode commands and responses described in this section are applicable when command +FCLASS=1.0 as shown in Table 6-1.

Mode Commands

Command: +FAA	Auto Answer Enable - Class 1.0
Description:	This command enables or disables fax adaptive answer. This command
	operates identically to the +FAE command.
Defined Values:	<value> Decimal number corresponding to the selected option.
	0	Disable data /fax auto answer mode. (Default.)
	1	Enable data /fax auto answer mode. The modem determines the calling
	type and issues DATA result code (13) if the caller is a data modem or issues
	FAX result code (15) if the caller is a fax modem.

Command: +FAE	Auto Answer Enable - Class 1 and 1.0
Description:	This command enables or disables fax adaptive answer. This command
	operates identically to the +FAA command.
Defined Values:	<value> Decimal number corresponding to the selected option.
	0 Disable data /fax auto answer mode. (Default.)
	1 Enable data /fax auto answer mode. The modem determines the calling
	type and issues DATA result code (13) if the caller is a data modem or issues
	FAX result code (15) if the caller is a fax modem.
	After a data (not fax) connection is achieved (indicated by the DATA result
	code), the DTE must issue an ATO command to cause the modem to go on-
	line.

Command: +FTS	Transmit Silence
Description:	This command causes the modem to terminate a transmission and wait for
	<time> 10-ms intervals before responding with the OK result code.
Defined Values:	<time> Decimal number from 0 (default) to 255 that specifies the length of
	time in 10-ms intervals to delay before responding with the OK result code
	after terminating the session.
Result Codes:	OK Reported when transmission has been terminated for the specified
	amount of time.
	ERROR <value> is invalid or this command is issued while the modem is on-
	hook.

Reporting Supported Range of Parameter Values:

Command: +FTS=?

Response: +FTS: <time> range

Example: +FTS: 0-255.

Multi-Tech Systems, Inc. SocketModem MT5600SMI Developer’s Guide 90