Multi-Tech Systems MT5600SMI-XL92, MT5600SMI-XL34 PCM Upstream Ignore, Modem-on-Hold Hook Flash

			Chapter 5 – AT Commands, S-Registers, and Result Codes
Command:	+PIG	PCM Upstream Ignore
Description:		Controls the selection of PCM upstream in the modem. The actual state of
		PCM upstream is determined by the state of this command as well as the
		state of a negotiated handshake with a V.92-compliant server in V.92
		Mode.
Defined Values:		+PIG0	Enable PCM upstream negotiation.
		+PIG1	Disable PCM upstream negotiation. (Default.)
Result Codes:		OK 0 or 1 in V.92 Mode (+MS=V.92)
		ERROR
Report Commands:		+PIG?	Reports Selected Value(s).
			Response: +PIG: <value>
			Example: +PIG: 1 For the default setting.
		+PIG=?	Reports Supported Range of Parameter Values.
			Response: +PIG: (<value> range)
			Example: +PCW: (0,1)
Command:	+PMHF	V.92 Modem-on-Hold Hook Flash
Description:		Causes the modem to initiate the flash hook sequence when in the
		modem-on- hold procedure. This enables switching to the second call
		(incoming or outgoing).
		This command applies only to V.92 modem-on-hold. There are no
		parameters associated with this command.
Result Code:		OK	When the modem completes the flash hook sequence.
		ERROR	If this command is initiated and the modem is not on hold.
Command:	+PQC	V.92 Phase 1 and Phase 2 Control
Description:		Controls the global enabling or disabling of the V.92 shortened Phase 1
		and Phase 2 startup procedures. This command is used in conjunction with
		the +PSS command.
Defined Values:		+PQC0	Enable Short Phase 1 and Short Phase 2. (Default.)
		+PQC1	Enable Short Phase 1 only.
		+PQC2	Not supported.
		+PQC3	Disable Short Phase 1 and Short Phase 2.
Result Codes:		OK 0, 1, or 3 in V.92 Mode (+MS=V.92)
		ERROR
Report Commands:		+PQC?	Reports Selected Values.
			Response: +PQC: <value>
			Example: +PQC: 0
		+PQC=?	Reports Supported Range of Parameter Values.
			Response: +PQC: (<value> range)
			Example: +PQC: (0,1,3)

Multi-Tech Systems, Inc. SocketModem MT5600SMI Developer’s Guide 73