Multi-Tech Systems MT5600SMI-P92, MT5600SMI-XL34, MT5600SMI-PL92 Command +FRM Receive Facsimile

Chapter 6 – Fax Class 1 and Class 1.0 Commands

Reporting Current or Selected Values: Command: +FTM? Response: +FTM: <mod>

Example: +FTM: 98 For V.17 9600 bps.

Reporting Supported Range of Parameter Values: Command: +FTM=?

Response: +FTM: (<mod> range)

Example: +FTM: 3,24,48,72,73,74,96,97,98,121,122,145,146

Command: +FRM	Receive Facsimile
Description:	This command causes the modem to enter the receiver mode using the
	modulation defined below.
Defined Values:	<mod> Decimal number corresponding to the selected modulation mode and
	data rates shown in Table 6-2.

Reporting Current or Selected Values:

	Command: +FRM?
	Response: +FRM: <mod>
	Example: +FRM: 98 For V.17 9600 bps.
Reporting Supported Range of Parameter Values:
	Command: +FRM=?
	Response: +FRM: (<mod> range)
	Example: +FRM: 3,24,48,72,73,74,96,97,98,121,122,145,146
Result Codes:	CONNECT Reported when the selected carrier is detected.
	+FCERROR Reported if another carrier is detected and FAR=0; the modem
	then returns to the command state.
	NO CARRIER Reported if loss-of-carrier is detected.
	OK Reported if the DTE sends any character to the modem other than XON or
	XOFF while operating in configured flow control from the DTE; the modem
	then returns to the command state.

Command: FTH	Transmit Data with HDLC Framing
Description:	This command causes the modem to transmit data using HDLC protocol and
	the modulation defined below.
Defined Values:	<mod> Decimal number corresponding to the selected modulation mode and
	data rates shown in Table 6-2.
Result Codes:	CONNECT Reported for either of two conditions:
	1. At the beginning of transmission of the training pattern for the selected
	modulation.
	2. If the Final Frame bit is 0.
	OK Reported for either of two conditions:
	1. If the Final Frame Bit is 1.
	2. if the DTE sends only <DLE><ETX> (a null frame) while transmitting flags.
	ERROR Reported if five seconds elapse from the time when the modem
	reported the CONNECT result code without any additional data transmitted
	from the DTE; the modem then turns off carrier and returns to the command

mode.

Reporting Current or Selected Values: Command: +FTH? Response: +FTH: <mod>

Example: +FTH: 98 For V.17 9600 bps.

Reporting Supported Range of Parameter Values: Command: +FTH? Response: +FTH?

Example: +FTH: 98 For V.17 9600 bps.

Multi-Tech Systems, Inc. SocketModem MT5600SMI Developer’s Guide 92