Multi-Tech Systems MT5600SMI-PL92, MT5600SMI-XL34 Command +FRH Receive Data with Hdlc Framing

	Chapter 6 – Fax Class 1 and Class 1.0 Commands
Command: +FRH	Receive Data with HDLC Framing
Description:	This command causes the modem to receive frames using HDLC protocol
	and the modulation defined below. An ERROR response code results if this
	command is issued while the modem is on-hook.
Defined Values:	<mod> Decimal number corresponding to the selected modulation mode and
	data rates shown in Table 6-2.
Reporting Current or Selected Values:
	Command: +FRH?

Response: +FRH: <mod>

	Example: +FRH: 98 For V.17 9600 bps.
Reporting Supported Range of Parameter Values:
	Command: +FRH?
	Response: +FRH?
	Example: +FRH: 98 For V.17 9600 bps.
Result Codes:	CONNECT Reported for either of two conditions:
	1. When the selected carrier is detected with an HDLC flag.
	2. If the DTE sends another +FTH=<MOD> command after sending the result

code indicating frame reception is complete.

+FCERROR Reported if a different carrier is detected and FAR=0. NO CARRIER Reported if loss of carrier is detected.

OK Reported for either of two conditions:

1. If a frame was received correctly.

2. If the DTE sends any character other than XON or XOFF while the modem is in the configured flow control.

ERROR Reported if a frame was received in error.

Multi-Tech Systems, Inc. SocketModem MT5600SMI Developer’s Guide 93