Multi-Tech Systems MT5600SMI-92, MT5600SMI-XL34 Error Control Commands, Origrqst, Origfbk, Ansfbk

		Chapter 5 – AT Commands, S-Registers, and Result Codes
Error Control Commands
Command: +ES	Error Control and Synchronous Mode Selection
Description:	This extended-format command specifies the initial requested mode of
	operation when the modem is operating as the originator. Optionally
	specifies the acceptable fallback mode of operation when the modem is
	operating as the originator, and optionally specifies the acceptable fallback
	mode of operation when the modem is operating as the answerer. Accepts
	three numeric subparameters.
Default:	Varies by request
Defined Values:	<orig_rqst>
	Decimal number specifies the initial requested mode of operation when the
	modem is operating as the originator. The options are:
	+ES0	Initiate call with Direct Mode.
	+ES1	Initiate call with Normal Mode (also referred to as Buffered Mode)
		only.
	+ES2	Initiate V.42 without Detection Phase. If V.8 is in use, disable V.42
		Detection Phase.
	+ES3	Initiate V.42 with Detection Phase. (Default.)
	+ES4	Initiate MNP.
	+ES6	Initiate V.80 Synchronous Access Mode when connection is
		completed, and Data State is entered. (See +ESA and +ITF
		commands.)
	+ES7	Initiate Frame Tunneling Mode when connection is complete, and
		Data Mode is entered.
	<orig_fbk>
	Decimal number specifies the acceptable fallback mode of operation when
	the modem is operating as the originator.
	+ES0	LAPM, MNP, or Normal Mode error control optional. (Default.)
	+ES1	LAPM, MNP, or Direct Mode error control optional.
	+ES2	LAPM or MNP error control required; disconnect if error control is
		not established.
	+ES3	LAPM error control required; disconnect if error control is not
		established.
	+ES4	MNP error control required; disconnect if error control is not
		established.
	<ans_fbk>
	Decimal number specifies the acceptable fallback mode of operation when
	the modem is operating as the answerer or specifies V.80 Synchronous
	Access Mode.
	+ES0	Direct Mode.
	+ES1	Error control disabled, use Normal Mode.
	+ES2	LAPM, MNP, or Normal Mode error control optional. (Default.)
	+ES3	LAPM, MNP, or Direct Mode error control optional.
	+ES4	LAPM or MNP error control required; disconnect if error control is
		not established.
	+ES5	LAPM error control required; disconnect if error control is not
		established.
	+ES6	MNP error control required; disconnect if error control is not
		established.
	+ES8	Initiate V.80 Synchronous Access Mode when connection is
		completed and Data State is entered (see +ESA and +ITF).
	+ES9	Initiate Frame Tunneling Mode when connection is complete, and
		Data Mode is entered.
Examples:	+ES=6	Enable V.80 Synchronous Access Mode originator.
	+ES=6	Enable V.80 Synchronous Access Mode originator.
	+ES=,,8	Enable V.80 Synchronous Access Mode answerer.

Multi-Tech Systems, Inc. SocketModem MT5600SMI Developer’s Guide 55