MICROBOARDS TECHNOLOGY, LLC | HCL Series |
The loader will continue to remove discs from the Input Spindle and place those into drives until either all of the drives are full or all Input Spindles are empty.
Processing...
Please Wait
Loading... RESERVED
36% 121MB Loaded
Loader Processing Drive 1 -> Output Bin
Loader Processing Drive 1 <- Input Bin
It takes a few seconds for the autoloader to recognize all of the discs in the trays.
Once all of the discs are detected, the autoloader will detect the master disc and read the contents of the master disc into the reserve partition.
Once the master disc has been loaded, the autoloader will remove the master disc from the drive and place it onto the Output Spindle.
The loader will then pick up another blank disc and load it into the drive where the last master disc was placed.
Once the loading process is completed, the duplication process will start. When the duplication process is through, the loader will remove the discs from the drives and place successful copies onto the Output Spindles and place failed copies into the Reject Area.
In Multi Master Mode, the robotic arm continues to load more media into the drives from Input Spindles while the duplicated discs are placed in the Output Spindle. Once a new Master disc are been detected by any of the drives, this process will repeat for the new Master disc.
When all of the jobs are complete, and the autoloader detects all Input Spindles are empty, it presents you with the Input Bin Empty message:
Input Bin Empty (20) Press OK to Continue
Access Log File
OK?
Master #1, Total 20 Pass 20, Fail 0
Master #2, Total 40 Pass 40, Fail 0
Master #3, Total 30 Pass 30, Fail 0
2. Test
Press the 
OK button to continue and you will see the Access Log File screen:
Press the 
OK button to view the log file or press the 
ESC button to return to the 1.Copy menu. If you choose to see the log file, you will see a screen similar to below:
Use the 
Up or 
Down buttons to look at the log file for the various jobs. Press the 
ESC button to return to the 1.Copy menu
Use the Test menu or Test quick key to simulate the copy process. With simulation, write once recordable discs such as
Note: Due to physical limitations of the DVD+R recordable format, if you try to simulate DVD+R copying, you will encounter failure messages.
Warning: If you are using CD/DVD Rewritable discs as your media during the simulation, the content on those discs will be permanently erased.
Operation in Test mode is identical to operation in Copy mode. See Copy on page 14 for instructions.
17