MICROBOARDS TECHNOLOGY, LLC | HCL Series |
Loader Processing...
Please Wait
The loader will then start the Autocopy process.
Loader Processing Drive
Loading... RESERVED
60%4012MB
The loader will load the Master into the next available drive.
The loader will load the contents of the master disc into the RESERVED partition.
Once the content of the master disc has been loaded, the autoloader removes it from the drive, places it on the output spindle, and starts placing blank discs into the writer drives.
Loader Processing Drive 2<-Input Bin
This information screen shows what is happening. In this case, the loader has taken a disc from the input spindle and is placing it into Drive 2.
The loader will continue to remove discs from the input spindle and place them into drives until either all of the drives are full, or until it runs out of blank discs.
Processing...
Please Wait
It takes a few seconds for the autoloader to recognize all the discs.
After two or three seconds of processing time, the following Copy Progress screen will appear.
¾“H” indicates the source of the job resides in the Hard Drive.
¾“4012MB” indicates the capacity of the master disc. ¾“0” indicates you have made 0 copies so far.
¾“12%” indicates the current progress of the duplication.
Note: It is normal to see the progress indicator stay at 0% - 10% and 100% for approximately 30 seconds for CD duplication and up to one minute for DVD duplication. That is caused by the initializing and finalizing stages.
Once the duplication run is completed, the loader will remove the disc from the drive and will place either the successful copy on the output spindle or the bad copy in the reject area.
The loader will then pick up another blank disc and load it into the drive. This is then repeated for each drive.
Loader Processing...
Drive
Input Bin Empty(20) Reset Hoppers?
The copying process will continue until you run out of blank discs.
At this point you can either load more discs on to the input spindle(s) and press the 
OK button to continue, or press the 
ESC button to terminate your project.
11.10 DVD+R High Compatibility Mode
This feature allows you to turn the DVD+R High Compatibility Mode feature ON or OFF. The purpose of this feature is to increase the compatibility of DVD+R media with a broader range of DVD Video players. This process will increase the amount of time required to duplicate your disc(s).
Setup
10.DVD+R High Compatibility
Use the 
Up or 
Down button to select the DVD+R High Compatibility Mode menu and press the 
OK button to enter that menu.
Use the 
Up or 
Down button to select whether the DVD+R High Compatibility Mode is on or off, and press the 
OK button to select that option.
11.11 Disable Drives
This feature allows you to disable certain drives/trays when those drives/trays are producing high failure rates or not functioning properly.
27