HDD to CD Speed Adjusted to: 8x
Once your selection has been changed successfully, you will see the display to the left for 2 seconds:
You will automatically be returned to the Main Menu.
7. Select Source
The Select Source menu is used to set the Master Reading Source. In the autoloader, the Master Reading Source is always the Hard Drive.
8. Master Mode
The Master Mode menu is used to select between Single Master mode or Multi Master mode. For more information on the modes, see Single Master and Multi Master Modes on page 11.
Press the appropriate Quick Button to set the mode immediately.
Single Master & Multi Master
Quick Buttons
Microboards B.30 8. Master Mode
Alternately, you can use the 
Up or 
Down button at the Main Menu to find the 8. Master Mode menu.
Press the 
OK button on 8. Master Mode to change the mode.
Use the 
Up or 
Down button to choose between Single Master mode and Multi Master mode. Press the 
OK button to enter your selection. The system will return you back to the main menu.
9. Erase RW
Use the Erase RW menu to erase your Rewritable discs.
Microboards | B.30 | |
1. | Copy | (SM) |
|
| |
Microboards | B.30 | |
9. | Erase RW |
|
Use the 
Up or 
Down button to find the 9. Erase RW menu.
Press the 
OK button on 9. Erase RW to enter the menu.
There are two options:
¾Full Erase: This option erases the entire disc, destroying all previously written data in the process.
¾Quick Erase: This option erases the index (TOC) of the Rewritable disc, not the data section. It is much faster than Full Erase. However, the data section is still recoverable. In order to ensure all old content on the RW disc is completely erased and unable to be recovered for security purposes, you must utilize the FULL ERASE function.
Use the 
Up or 
Down buttons to select between the two options and press the 
OK button to continue.
Counter:
No Counter
Loader Processing Drive 1 <- Input Bin
Processing ...
Please Wait
Follow the instructions shown in Setting Counters on page 12 to continue. Once the counters have been set, press the 
OK button to confirm.
The Robotic Arm will pick the discs to be erased from the Input Spindles and place them into the drives. As soon as the drives are all full, or the number programmed into the counter is reached, you will see the following:
The system will check all discs in the drive and prepare them to be erased. As soon as the checking process completes, the Erase RW process starts.
20 • Operation