JVC HR-XVC15U manual Inserting Batteries, Battery precautions, Remote control basics

Page 11

 

 

Remote control

Inserting Batteries

 

 

1 Open the battery compart-

2 Install two "AA" batteries (supplied),

3 Replace the compartment

ment cover in the direction of

paying attention to the polarity

cover.

the arrow.

diagram in the battery compartment.

 

Battery precautions

The precautions below should be followed when using batteries in this device:

1.Use only the size and type of batteries specified.

2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device. To avoid a potential short circuit, insert the “–” end first.

3.Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.

4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)

Remote control basics

•Press POWER to turn the DVD/VCR on or off.

•Make sure TV/VCR/DVD switch is set to VCR/DVD.

•Tap VCR CH + or VCR CH – to move through the channels one channel at a time.

•The VCR CH +/– and SET +/– are also used to navigate on-screen menu system.

•You can directly access specific channels using Number keys pad.

•Each press of VCR or DVD, switches the screen between the VCR screen (VCR mode) and the DVD screen (DVD mode).

Operation

 

• Aim the remote control at the remote sensor and press control buttons

 

to operate.

 

• Operate the remote control within 30° angle on either side of the remote

Approx. 5 meters

sensor, up to a distance of Approx. 5 meters.

 

Change the custom code for remote control

If you operate this DVD/VCR with another JVC’s VCR simultaneously arranging them side by side, the both record- ers will react to this remote control. In this case, you can change the remote control and DVD/VCR to other frequency (“ ”). Then you can operate only this DVD/VCR with this changed remote control.

When you purchased, the DVD/VCR and remote control have been set to the frequency-“ ”.

Example: Change frequency to

Remote control:

While holding VCR, press 2 (code: b) of Number keys. (in case of code: A, press 1)

NOTES:

DVD/VCR:

In the POWER off mode, press and hold PLAY for more than 5 seconds. “b” will appear on the display and then disappear after approx. 4 seconds.

•If the remote control has been set to b, the DVD/VCR also must be set to b. Otherwise, the DVD/VCR can not be operated with this remote control.

•To reset to “A”, repeat above procedure. However press 1 instead of 2.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents DVD/CD Player Risk of Electric Shock Do not Open Location of the required MarkingPOWER-CORD Protection CleaningAccessories Power SourcesSafety Check Power LinesDamage Requiring Service Replacement PartsDisc Power sourceTo USE AC Power Source Laser BeamDVD Section FeaturesDVD/CD Player/Video Cassette Recorder VCR SectionContents Rear Parts and functionsFront Track display for CD Explanation for On-Screen-Symbol DVDDisplay Display windowJVC TV Remote Control Remote controlChange the custom code for remote control Remote controlBattery precautions Remote control basicsSeparate VHF and UHF Antennas Basic connectionsCombination VHF/UHF Antenna with 75 ohm Coaxial Cable Supplied Basic connections75/300 ohm outputs Ohm Coaxial Cable not suppliedCatv Cable TV connections Incoming SwitchCable Descrambler Switch Catv Cable TV connectionsConnect to a TV with S-VideoOutput / Component Video Output Playback connectionsConnect to a TV with Audio/Video Output Connect to a BS TunerConnect to an AV Amplifier with built-in digital surround Playback connectionsConnect to a Stereo Amplifier with Audio Output Enter Setting the video channel/Setting the languageSetting the Video Channel Setting the languageTV/CATV Selection Tuner settingSetting channels automatically Presetting the channels into memoryNoise elimination To ADD/DELETE channels/Noise eliminationTo ADD/DELETE channels Zone, then press the Enter OFF Auto clock settingDaylight Saving Time setting To make corrections any time during the process Manual clock settingLoading and Unloading a cassette tape To rewind the tape or forward it rapidly Forward/Reverse picture search modeCassette tape playback To stop playbackSpecial playback DISPLAY-button Zero Return function/Video Index Search systemZero Return function Video Index Search systemAppear on the display Recording a TV programRecording and viewing the same TV program Recording a TV program Select the channel to be recorded Instant Timer Recording ITRTo cancel ITR Press Number keys or VCR CH +/- toSet the start time, end time, channel Timer recordingConfirmation / Cancellation of the timer recording Timer-recordingTimer recording special case Case timer programs-overlapOutput selection Stereo Recording and PlaybackConnection with Camcorder Duplicating a video tapeDuplicating a disc material onto a video tape Connection with second VCRDisc Setup language can be selected Preparation Setting setup languagePress OPEN/CLOSE Playback procedureFrame Advance Fast Forward PlaybackReview Playback Still PlaybackLocating desired scene Zooming/Locating desired sceneZooming Repeat playback of Title, Chapter and Track Press Play Mode during playback or stop modeRepeat playback You can arrange the order of tracks on the disc Program playback/Random playback CDProgram playback Random playbackMP3/WMA CD playback MP3/WMA/JPEG CD information MP3/WMA/JPEG playbackAbout file menu Jpeg CD playbackPress OPEN/CLOSE or Play Off Setting the Jpeg IntervalSetting the Jpeg Interval Or EnterPictures Only Setting the Select FilesAll Music OnlyZoom mode, press Zoom repeatedly to return to a 11 view Off Zooming/Changing angles Jpeg CDChanging angles This unit will allow you to zoom in on the Jpeg imageReturning to the scenes To cancel the markMarking desired scenes Marking the scenesCase of Video CD playback Changing soundtrack language/Karaoke playbackChanging soundtrack language Karaoke playbackDVD menu Subtitles/Changing angles/Title selection/DVD menuTurning the Subtitles On and Off Title selectionParental control Parental control settingTo unlock the Parental Control Setting CancelTemporary disabling of rating level by DVD disc English, Francais, Espanol Setting menu languagePress or Enter To select Then press Menu Press To select your Desired Language, then pressAutomatic Setting subtitle languageOther Press To select Desired Audio Language Then Press Enter Setting audio soundtrack languageThen Press Audio YourPanscan Setting the aspect ratio of TV screenYou can select the aspect ratio for your TV Preparation LetterboxVideo Audio Setting on screen display/Status display of discStatus display of disc DVDEnter to Dynamic Range ControlLanguage code list VCR Problems and troubleshootingSymptoms Possible Solutions DVD/VCR Symptoms Possible Solutions Problems and troubleshooting/Video head cleaningVideo head cleaning Auto Clock SettingVCR section SpecificationsAccessories GeneralWhat WE will do What YOU Must do for Warranty ServiceWhat is not Covered For customer useNew Maple Avenue Pine Brook, NJ For Servicing Only in U.S.AJ2C31501A U 02/12
Top Page Image Contents