JVC HR-XVC26U manual Tape Remaining Time, Second Audio Recording, Set the counter display

EN 35

Elapsed Recording Time Indication

1Set the counter display.

Press DISPLAY until a counter reading appears on the front display panel.

2Reset the counter.

Press C.RESET before starting recording or playback.

●The counter is reset to “0:00:00” and shows the exact elapsed time as the tape runs. You can check the exact time of a recording or playback.

Tape Remaining Time

Press DISPLAY until the time remaining on the tape appears.

●The front display panel shows the tape remaining time with “:” blinking.

●By pressing the DISPLAY button, you can change display to show the channel position*, clock time, counter reading or tape remaining time.

*Channel position is not displayed during playback.

NOTES:

●When you press ON SCREEN, the on-screen display appears on the TV screen for 5 seconds, then the displays other than the counter disappears. To clear the counter display, press ON SCREEN.

●Depending on the type of tape being used, the tape remaining time reading may not appear right away, or is not correct.

“– –:– –” may sometimes appear with “:” blinking, or the display may blink on occasion.

Second Audio Recording

This unit’s built-in MTS decoder enables reception of Multichannel TV Sound broadcast. To record a SAP program received, set “2ND AUDIO RECORD” to “ON”. ( pg. 76)

NOTE:

When the channel is changed on the unit;

●The “STEREO” indicator appears on the screen for about 5 seconds if the program is a stereo broadcast.

●The “SAP” indicator appears on the screen for about 5 seconds if the program is a SAP broadcast.

●Both indicators appear when a stereo program is accompanied by SAP sound.