FUNAI DRV-B2734 Installing batteries in the remote control, VCR / DVD recorder Switching

Page 12

DRV_B2737_B2734.book Page 12 Thursday, March 31, 2005 10:04 PM

Before you start

Installing batteries in the remote control

Install two R6 (AA) batteries (supplied) into the remote control, carefully match with the polarity indicated inside the battery compartment.

1

2

3

Caution

•Incorrect use of batteries can result in hazards such as leakage and bursting.

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together.

•Make sure that the plus and minus ends of each battery match the indications inside the battery compartment.

•Remove batteries if the equipment will not be used for a month or more.

•When disposing used batteries, please comply with governmental regulations or the public instructions for environmental protection that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disassemble batteries.

About the remote control

•Make sure there is no obstacle between the remote control and the remote control sensor on the unit.

•Use within the operating range and angle as shown.

Within about 7 m

60˚

Remote control

•Remote control operation may become unreliable if the remote control sensor of the unit is being exposed by the strong sunlight or fluorescent light.

•Remote controls for different devices can interfere with each other. Be careful when using remote controls for other equipment located close to the unit.

•Replace the batteries when the operating range of the remote control reduces.

EN

12

VCR / DVD recorder Switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which component you wish to operate with [SELECT L P] on the front panel.

 

 

 

OPEN/CLOSE

 

 

STANDBY-ON

REW FFWD STOP/EJECT PLAY RECORD

PROG.

DUBBING

SELECT

STOP PLAY RECORD

 

 

 

VCR

SELECT

DVD

 

 

 

 

 

S-VIDEO VIDEO L(MONO)-AUDIO-R

SELECT

VCR SELECT DVD DVD SELECT indicator

VCR SELECT indicator

VCR mode

Press [VCR ] on the remote control. (Verify that the VCR SELECT indicator is lit.)

DVD mode

Press [DVD ] on the remote control. (Verify that the DVD SELECT indicator is lit.)

Note

•Pressing only [SELECT L P] on the front panel DOES NOT switch the mode of the remote control. You MUST select the correct mode on the remote control.

•Press [SELECT L P] to select the DVD mode or the VCR mode.

•You cannot switch to the mode (DVD or VCR) that is in the timer-standby mode.

•If the media is available, you can start recording by pressing [REC / OTR] (DVD) or [REC / OTR] (VCR) on the remote control even if another equipment (DVD or VCR) is selected. In this case, the mode of the remote control will be automatically switched to the appropriate component.

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Accessories Supplied Quick Setup GuidePrecautions Laser SafetyPower Supply Before you startInstallation Location Connection to PowerAvoid the Hazards of Electrical Shock and Fire Moisture Condensation WarningMaintenance Cleaning the UnitAbout Copyright Table of contents Features RecordingPlayback EditingSymbol Description Button names describedThere may be a disc which cannot be used or played back Functional overview Front panelRear Panel Mains cable Audio OUT jacks DVDVideo OUT jack DVD Digital Audio OUT DVD Optical DRV-B2737 only, Coaxial jacksRemote Control Timer PROG. button DVD / VCR Setup button DVD / VCRRepeat button DVD Clear button DVD / VCRInstalling batteries in the remote control VCR / DVD recorder SwitchingAbout the remote control VCR Select DVD DVD Select indicator VCR Select indicatorSetting menus Easy Setting MenuGuide to On Screen Displays Display menuAdvanced Setting Menu Front Panel Display Guide Display messagesConnecting to a TV Connecting to external equipmentGetting Started ConnectionsConnecting to an MD deck or DAT deck Digital audio for better sound quality only for DVDAfter you have completed connections Connections illustrated above are optional for better soundChannel setting Auto tuningManual tuning Press Setup to exitTo skip a Preset channel After completion, press Setup to exitTo select a channel MoveSetting the clock Auto Clock SettingManual Clock Setting Selecting the TV aspect ratio If you have a standard TVRecording Information on DVD recordingType of discs Recording speedFeatures Information on copy controlMaking discs playable in other DVD players Finalise Usable discsSetting Auto Chapter Formatting a discChoosing the recording format of a blank DVD-RW disc You cannot set or clear chapter markers on DVD-R discs. SeeSelecting the Sound mode Setting External input audioInsert a recordable disc Stop mode, press Setup Reformatting a disc manuallySetting Bilingual Recording Audio Basic recordingTurn on the unit and insert a recordable disc Press DVDOne-touch timer recording OTR Checking the recording picture and sound qualityPress REC Monitor again to exit 030 Normal Recording 800Timer recording Enter the date using Cursor U / D, then press Cursor PTimer Programming list will appear 1st JanuaryTo exit, press Setup or Timer Prog Press T-SETCheck the information on the list you will need If PDC is onTo stop the timer recording in progress If the timer programming did not complete correctlyHints for timer recording PDC Programme Delivery ControlPriority of overlapped settings If the starting time is sameIf the recording time is partially overlapped If the recording time entirely overlapsSettings for external equipment Connection to external equipmentRecording from external equipment Dubbing Mode Select VCR→DVD using Cursor U / D, then press EnterPress Setup to exit the setting menu Press DVD Select DVD→VCR using Cursor U / D, then press EnterSetting a disc to protect To cancel the disc protectFinalising discs DVD to VCR duplication will startAuto finalise Finalising is completePlaying back discs Information on playing back DVDsBasic playback Playing back a DVD-RW / DVD-R / DVD+RW / DVD+R discPlaying back a DVD-V / CD / Video CD Playing back an MP3 / JpegPlaying back discs using the disc menu Kodak Picture CDPress DVD first Press Stop S to stop playbackPlaying back a disc using the title menu Playing back a Video CD using the title menu Cancelling and Recalling the PBC functionInsert a Video CD Stop mode, press Setup PBC function for Video CDsSpecial playback Marker Setup Slow forward / Slow reverse playbackZoom Search Title / Chapter searchSearching for a Title Searching for a ChapterTrack search Direct SearchRepeat / Random / Program playback / Slide Show Repeat playbackRandom playback Program playbackSwitching subtitles Switching audio soundtrackSelect the icon using Cursor L / P, then press Enter Selecting the format of audio and videoSwitching camera angles Angle will switch each time you press EnterReducing block noise Editing discs in Video mode EditingDisc editing Guide to a title listPress Setup Guide to editing title namesEditing titles Setting or clearing chapter markers Then press EnterEditing discs in VR mode Original Editing Original titles in VR modeOriginal Deleting titles Editing original titles OriginalTo protect a whole disc DVD-RW VR mode only Original Protecting titlesOriginal Releasing titles from protecting Key icon will disappear from the title in the original listPlaylist Editing the Playlist in VR mode Select Yes using Cursor U / DPlaylist Deleting titles Playlist Deleting parts of titles Scene DeletePlaylist Setting or clearing chapter markers Playlist Editing titlesAdding a chapter marker Deleting a chapter markerPlaylist Setting pictures as thumbnails Playlist Dividing a titlePlaylist Combining titles Playlist Adding titles to a Playlist Playlist Deleting a PlaylistPlaylist can be deleted if it is no longer needed Playlist is deletedChanging the Setting menu Tour of the Setting menuLanguage setting Disc Menu Language Default EnglishAudio Language Default Original Subtitle Language Default OFFDisplay setting Audio settingFL Dimmer Default Bright Screen Saver Default 10 minutesDynamic Range Control Default on Fast Forward with Audio Default OFFDolby Digital conversion Default Stream Settings for Mpeg Default PCMParental Lock Default All Enter the current password using the Number buttonsPassword is not yet set Password is already setSetting TV system Changing Video Out systemRecording and one-touch timer recording OTR VCR functionsPlayback Basic RecordingOne-touch timer recording Index searchTime search Accidental erasure preventionMode Audio output Display on Other operationsHi-Fi Stereo Sound System Troubleshooting Symptom RemedyOthers DVD VCRDVD Open / Close / Eject OVCR Pressing REC / OTRError message Cause Solution ALLLanguage code Language CodeGlossary Specifications GeneralRecording TunerDRVB2737B2734.book Page 73 Thursday, March 31, 2005 1004 PM DRVB2737B2734.book Page 74 Thursday, March 31, 2005 1004 PM DRVB2737B2734.book Page 75 Thursday, March 31, 2005 1004 PM Declaration of Conformity EEC
Top Page Image Contents