FUNAI DRV-B2734, DRV-B2737 owner manual Setting the clock, Auto Clock Setting, Manual Clock Setting

DRV_B2737_B2734.book Page 20 Thursday, March 31, 2005 10:04 PM

Getting Started

Setting the clock

Auto Clock Setting

Channel Tuning must be set before setting Auto Clock.

1 In stop mode, press [SETUP].

2 Select “Advanced Setting Menu” using [Cursor U / D], then press [ENTER].

If it has already appeared, proceed to step 3.

3 Select “Clock” using [Cursor U / D], then press [ENTER].

Advanced Setting Menu

Playback

Recording

Display

Select Video

Clock

Channel

Disc

Easy Setting Menu

4 Select “Auto Clock Setting” using [Cursor U / D], then press [ENTER].

5 Select “ON” using [Cursor U / D], then press [ENTER].

The current time will be set automatically.

6 Press [SETUP] to exit.

7 Press [STANDBY-ON] to turn off.

The Auto clock function is activated.

This unit will search for the time only when the power is off. Leave the unit off for several minutes to give it time to set the clock.

Hint

•If you want to cancel “Auto Clock Setting,” select “OFF” using [Cursor U / D], and then press [ENTER] at step 5.

Note

•The default setting of “Auto Clock Setting” is “OFF.”

•The clock may set itself automatically after you connect the antenna cable to the unit and plug in the mains cable. In this case, the current time will appear on the front panel display.

•To set the clock automatically, the channel assigned to position 01 must receive the PDC signal.

•The clock cannot be set automatically if you are not receiving a channel in your area that carries a time signal. In this case, set the clock manually.

•Once the auto clock setting is performed, the unit will correct the current time by receiving PDC broadcasts whenever you turn off the unit.

•The unit will correct the current time automatically at 8:00, if the unit power is turned off.

•Between 23:00 and 1:00, the AUTO CLOCK function will not operate even if the unit power is turned off.

Manual Clock Setting

1	In stop mode, press [SETUP].
	“Easy Setting Menu” or “Advanced Setting Menu”
2	will appear.
	Select “Clock” using [Cursor U / D],
	then press [ENTER].
3	If you select “Advanced Setting
	Menu,” proceed to step 4.
	If you select “Easy Setting Menu,”
	proceed to step 5.
4	Select “Clock Setting” using
	[Cursor U / D], then press [ENTER].
5	Press [ENTER] again.
	The default date will appear.
		Clock Setting	VCR	DVD

01/ 01/ 2005(SAT)

0:00

6 Enter the date (day / month / year) using [Cursor U / D], then press [Cursor P].

Press [Cursor P] to move the cursor to the next field. If you wish to go back to the previous field, press [Cursor L].

7 Enter the time (hours / minutes) using [Cursor U / D], then press [ENTER].

The clock will start.

•Although seconds are not displayed, they will be counted from zero.

8 Press [SETUP] to exit.

Note

•Your clock setting will be lost if either there is a power failure or the unit is unplugged for more than 30 seconds when the “Auto Clock Setting” is “OFF.”

EN 20