FUNAI DRV-B2734, DRV-B2737 owner manual Others, Troubleshooting, Dvd Vcr, Symptom Remedy

Page 66

DRV_B2737_B2734.book Page 66 Thursday, March 31, 2005 10:04 PM

Others

Others

Troubleshooting

Before requesting service for this unit, check the table below for a possible cause of the problem you are experiencing. Some simple checks or a minor adjustment by you may eliminate the problem and restore correct operation.

 

 

DVD • VCR

 

 

 

 

 

 

 

 

 

Symptom

 

Remedy

 

The power does not turn on.

 

• Check the mains cable is connected securely.

 

 

 

• Check building circuit the breaker (In case of power failure) .

 

 

 

 

 

There is no picture.

 

• Check signal cables are connected securely.

 

 

 

• Check if a connecting cable is damaged.

 

 

 

• Check connections to your TV. (See page 16.)

 

 

 

• Switch the input selector on your TV (to “AV1,” for example) until a picture

 

 

 

appears on the screen.

 

 

 

 

 

TV programme picture does not fill the

 

• Set channels with “Auto Tuning” from the screen menu. (See page 18.)

 

screen.

 

• Select the channel of a TV program using [PROG. U / D].

 

 

 

 

 

TV programme pictures are distorted.

 

• Adjust the direction of the TV antenna.

 

 

 

• Adjust the picture (see the TV instruction manual).

 

 

 

• Place the antenna and the TV farther apart.

 

 

 

• Separate any bunched antenna cables and the TV.

 

 

 

 

 

TV channel cannot be changed.

 

• Switch the TV input.

 

 

 

• Check if the antenna cable is connected correctly. (See page 16.)

 

 

 

 

 

The channel cannot be changed from the

 

• Set the TV input to “TV.”

 

channel you are recording.

 

 

 

 

 

 

 

Playback picture is distorted.

 

• Do not bring equipment that may cause electrical interference, such as a

 

 

 

cellular phone, near the unit.

 

 

 

 

 

The playback picture or TV programme from

 

• If a DVD player, VCR or tuner is connected to your TV via the unit, the copy-

 

equipment connected through the unit is

 

protection signal applied to some programs could affect picture quality.

 

distorted.

 

Disconnect the playback equipment in question and connect it directly to your

 

 

 

TV.

 

 

 

 

 

Nothing was recorded even though you set

 

• There was a power failure during recording.

 

the timer setting correctly.

 

• The unit’s internal clock stopped due to a power failure that lasted for more

 

 

 

than 30 seconds.

 

 

 

• Reset the clock. (See page 20.)

 

 

 

• Unplug the mains cable from the AC outlet and plug it in again.

 

 

 

• The programme contains copy protection signals that restrict copying.

 

 

 

• The timer setting overlapped with another setting that was set later or has

 

 

 

priority.

 

 

 

 

 

Timer recording is not complete or did not

 

• The timer setting overlapped with another setting that was set later or has

 

start from the beginning.

 

priority. (See page 30.)

 

 

 

• There was not enough disc space.

 

 

 

 

 

There is no sound.

 

• The disc is dirty or flawed.

 

 

 

• Check if all cables are connected securely.

 

 

 

• Check if a connecting cable is damaged.

 

 

 

• Check the connections to the amplifier input.

 

 

 

• Check if the input source setting on the amplifier is correct.

 

 

 

• Check if the recorder is in Pause mode or in Slow-motion Playback mode.

 

 

 

• Check if the recorder is in Fast Forward or Fast Reverse mode.

 

Timer recording is not possible.

• Make sure

 

indicator appears on the front panel display of this unit. If not,

 

press [T-SET].

 

 

 

 

The remote control does not function.

• Batteries are exhausted.

•There are obstacles between the remote control and the unit.

•The remote control is too far from the unit.

•There are no batteries in the remote control.

•The unit is not turned on.

•The remote control is not pointed at the remote sensor on the unit.

•Press [DVD ] or [VCR ], whichever you need. Then, try again.

•If the above remedies do not solve the problem, please call the Service Centre for help.

The unit does not operate correctly.

• If static electricity or anything else causes the unit to operate abnormally,

 

unplug the mains cable and plug it in again.

 

 

EN

66

 

 

 

 

 

 

 

 

 

Page 65 Page 67
Image 66
Page 65 Page 67
Contents Accessories Supplied Quick Setup GuidePower Supply PrecautionsLaser Safety Before you startAvoid the Hazards of Electrical Shock and Fire Installation LocationConnection to Power Moisture Condensation WarningMaintenance Cleaning the UnitAbout Copyright Table of contents Playback FeaturesRecording EditingSymbol Description Button names describedThere may be a disc which cannot be used or played back Functional overview Front panelVideo OUT jack DVD Rear PanelMains cable Audio OUT jacks DVD Digital Audio OUT DVD Optical DRV-B2737 only, Coaxial jacksRemote Control Repeat button DVD Timer PROG. button DVD / VCRSetup button DVD / VCR Clear button DVD / VCRAbout the remote control Installing batteries in the remote controlVCR / DVD recorder Switching VCR Select DVD DVD Select indicator VCR Select indicatorGuide to On Screen Displays Setting menusEasy Setting Menu Display menuAdvanced Setting Menu Front Panel Display Guide Display messagesGetting Started Connecting to a TVConnecting to external equipment ConnectionsAfter you have completed connections Connecting to an MD deck or DAT deckDigital audio for better sound quality only for DVD Connections illustrated above are optional for better soundManual tuning Channel settingAuto tuning Press Setup to exitTo select a channel To skip a Preset channelAfter completion, press Setup to exit MoveSetting the clock Auto Clock SettingManual Clock Setting Selecting the TV aspect ratio If you have a standard TVType of discs RecordingInformation on DVD recording Recording speedMaking discs playable in other DVD players Finalise FeaturesInformation on copy control Usable discsChoosing the recording format of a blank DVD-RW disc Setting Auto ChapterFormatting a disc You cannot set or clear chapter markers on DVD-R discs. SeeInsert a recordable disc Stop mode, press Setup Selecting the Sound modeSetting External input audio Reformatting a disc manuallyTurn on the unit and insert a recordable disc Setting Bilingual Recording AudioBasic recording Press DVDPress REC Monitor again to exit One-touch timer recording OTRChecking the recording picture and sound quality 030 Normal Recording 800Timer Programming list will appear Timer recordingEnter the date using Cursor U / D, then press Cursor P 1st JanuaryCheck the information on the list you will need To exit, press Setup or Timer ProgPress T-SET If PDC is onHints for timer recording To stop the timer recording in progressIf the timer programming did not complete correctly PDC Programme Delivery ControlIf the recording time is partially overlapped Priority of overlapped settingsIf the starting time is same If the recording time entirely overlapsSettings for external equipment Connection to external equipmentRecording from external equipment Press Setup to exit the setting menu Press DVD Dubbing ModeSelect VCR→DVD using Cursor U / D, then press Enter Select DVD→VCR using Cursor U / D, then press EnterFinalising discs Setting a disc to protectTo cancel the disc protect DVD to VCR duplication will startAuto finalise Finalising is completePlaying back discs Information on playing back DVDsPlaying back a DVD-V / CD / Video CD Basic playbackPlaying back a DVD-RW / DVD-R / DVD+RW / DVD+R disc Playing back an MP3 / JpegPress DVD first Playing back discs using the disc menuKodak Picture CD Press Stop S to stop playbackPlaying back a disc using the title menu Insert a Video CD Stop mode, press Setup Playing back a Video CD using the title menuCancelling and Recalling the PBC function PBC function for Video CDsSpecial playback Marker Setup Slow forward / Slow reverse playbackZoom Searching for a Title SearchTitle / Chapter search Searching for a ChapterTrack search Direct SearchRandom playback Repeat / Random / Program playback / Slide ShowRepeat playback Program playbackSelect the icon using Cursor L / P, then press Enter Switching subtitlesSwitching audio soundtrack Selecting the format of audio and videoSwitching camera angles Angle will switch each time you press EnterReducing block noise Disc editing Editing discs in Video modeEditing Guide to a title listPress Setup Guide to editing title namesEditing titles Setting or clearing chapter markers Then press EnterOriginal Deleting titles Editing discs in VR modeOriginal Editing Original titles in VR mode Editing original titles OriginalOriginal Releasing titles from protecting To protect a whole disc DVD-RW VR mode onlyOriginal Protecting titles Key icon will disappear from the title in the original listPlaylist Deleting titles Playlist Editing the Playlist in VR modeSelect Yes using Cursor U / D Playlist Deleting parts of titles Scene DeleteAdding a chapter marker Playlist Setting or clearing chapter markersPlaylist Editing titles Deleting a chapter markerPlaylist Setting pictures as thumbnails Playlist Dividing a titlePlaylist Combining titles Playlist can be deleted if it is no longer needed Playlist Adding titles to a PlaylistPlaylist Deleting a Playlist Playlist is deletedChanging the Setting menu Tour of the Setting menuAudio Language Default Original Language settingDisc Menu Language Default English Subtitle Language Default OFFFL Dimmer Default Bright Display settingAudio setting Screen Saver Default 10 minutesDolby Digital conversion Default Stream Dynamic Range Control Default onFast Forward with Audio Default OFF Settings for Mpeg Default PCMPassword is not yet set Parental Lock Default AllEnter the current password using the Number buttons Password is already setSetting TV system Changing Video Out systemPlayback Recording and one-touch timer recording OTRVCR functions Basic RecordingTime search One-touch timer recordingIndex search Accidental erasure preventionMode Audio output Display on Other operationsHi-Fi Stereo Sound System Others TroubleshootingSymptom Remedy DVD VCRDVD Open / Close / Eject OVCR Pressing REC / OTRError message Cause Solution ALLLanguage code Language CodeGlossary Recording SpecificationsGeneral TunerDRVB2737B2734.book Page 73 Thursday, March 31, 2005 1004 PM DRVB2737B2734.book Page 74 Thursday, March 31, 2005 1004 PM DRVB2737B2734.book Page 75 Thursday, March 31, 2005 1004 PM Declaration of Conformity EEC
Top Page Image Contents