FUNAI DRV-B2734, DRV-B2737 Settings for external equipment, Connection to external equipment

DRV_B2737_B2734.book Page 32 Thursday, March 31, 2005 10:04 PM

Settings for external equipment

Connection to external equipment

Video	VR		VCR
DVD-RW	DVD-RW	DVD-R

Connect the external equipment using either the input jacks, AV1, AV2, (Rear) or AV3 (Front). However, for AV3 jacks, you have to select S-VIDEO input or VIDEO input jacks depending on the connected devices.

Use commercially available Scart, S-Video or Video cable and an Audio cable for this connection.

	1	In stop mode, press [SETUP].
	2	Select “Advanced Setting Menu”
		using [Cursor U / D], then press
Recording
		[ENTER].
	3	If it has already appeared, proceed to step 3.
		Select “Select Video” using
		[Cursor U / D], then press [ENTER].
	4	Press [ENTER].
	5	Select the input jack type to be used
		using [Cursor U / D], then press
		[ENTER].
			AV3 (Front)	VCR	DVD
			Video In
			S-Video In

•If you want to use VIDEO input jack (Composite), select “Video In.”

•If you want to use S-VIDEO input jack, select “S- Video In.”

6 Press [SETUP] to exit.

Recording from external equipment

Video	VR		VCR
DVD-RW	DVD-RW	DVD-R

Before recording from external equipment, see page 16 for connection instructions.

1 Turn the TV and the unit on, and select the input of the TV to which the unit is connected.

2 When you want to record to the disc: Press [DVD ].

Press [OPEN / CLOSE / EJECT O] to open the disc tray, then place the disc to record on.

Press [OPEN / CLOSE / EJECT O] again to close the disc tray.

When you want to record to a tape:

Press [VCR ].

Insert the tape with a record tab into the cassette compartment.

3 Select the input terminal to which the external equipment is connected. (AV1, AV2 or AV3)

To use the input jacks on the back of the unit, select the “AV1,” “AV2,” position by pressing [0], [0], [1] or [0], [0], [2] on the remote control or using [PROG. U / D].

To use the input jacks on the front of this unit, select “AV3” position by pressing [0], [0], [3] on the remote control or using [PROG. U / D].

4 Select a recording speed using [REC SPEED].

Refer to “Recording speed” on page 22 for DVD or page 63 for VCR.

5 Press [RECORD] on the unit to start recording.

6 Press the PLAY button on the external recording component.

7 For disc:

Press [STOP S] on the unit to stop recording.

For tape:

Press [STOP / EJECTSO] on the unit to stop recording.

EN 32