Nokia 9802 S Modem configuration, Position of the RGB output, Information about the modem

Page 38

MAIN MENU

Position of the RGB output

 

Adjust the horizontal position of the TV picture with the

but-

tons. (The “TV signal,” see above, must be set to RGB for this function to work.)

Time adjustment

The time is adjusted by using the

buttons, ± 1/2 an hour at

a time.

 

 

You can also adjust the minutes by using the

buttons.

Modem configuration

The modem function is only working in the Scandinavian countries and Greece.

The Mediamaster is equipped with a built in telephone modem. Via the modem so called “interactive services”, such as e.g. or- dering movies, can be performed.

You will get more information concerning this service by your service provider. More information may also be available in the “System information” menu, ref. to page 42.

When configurating the modem, the following parameters have to be set.

Country: Select the country where the box is installed.

Pulse or tone: Select the alternative valid for your system. If in doubt, please contakt your phone operator.

Prefix: If the connection has to pass a switch board, enter the figure that will open the line.

Information about the modem

This equipment has been approved pursuant to Council Decision 98/482/EC [CTR 21] for pan-European single terminal connection to the Public Switched telephone Network (PSTN). However, due to differences between the individual PSTNs provided in differ- ent countries, the approval does not, of itself, give an uncondi- tional assurance of successful operation on every PSTN termina- tion point.

In the event of problems, you sholud contact your equipment supplier in the first instance.

GB 38

Image 38
Contents Mediamaster Page Contents Mediamaster 9802 SFor Your Safety General Information about the MediamasterRemote Control + PRear panel Front and Rear PanelFront panel About the Smartcard and CA Module Viaccess smartcardOnly for services coded with the Viaccess CA system CA module with its smartcardConnecting the Mediamaster to the dish Installation of the MediamasterPreparing the remote control About the Scart socketsGeneral Connecting to the TVConnecting a TV and VCR If your TV has a Scart socket, but your VCR does notConnecting to the built in phone modem Connecting a satellite receiver and a VCRConnecting a HiFi system Nokia smart switchTuning your TV to the Mediamaster Switching on for the first time with Scart connectionsTuning procedure when RF connections are used Welcome menu First Time InstallationGeneral information LanguageAlternatives 1-6 requires the use of a Universal LNBs RF modulator typeAntenna/satellite selection Line 1 through 4 on the antenna satel- lite selection menu About Signal strength AGC and Signal quality SNRAntenna adjustment and signal check Connection of a DiSEqC switch Line 5 and 6 on the antenna satellite selection menuOne antenna/one LNB configuration Line 7 on the antenna satellite selection MenuSwitch type and port Multisatellite/mini DiSEqC and two port DiSEqCDiSEqC switch with 4 inputs Manual search Advanced searchMotor antenna Type of motorAdjust motor Press OKFirst Time Installation Channel search progress Time adjustmentFinishing the first time installation Viewing Mode Programme informationI information button GuideAudio language List of TV and radio channelsOptions green button Subtitle languageText button teletext TV releaseVideo recording Edit channels Main MenuTV and radio channels Important about editing channelsRename list How to give a specific nameCreate list Rearrange listsRename channels Select channelsLock channels Remove channels Rearrange channelsDelete channels To remove channelsUpdate channels Update channels via a PCAutomatic search System configurationChannel search Manual search For a fixed antenna Edit satellitesTo add a new satellite Delete satellite When your antenna is controlled by a motorView attributes Antenna/Satellite configuration TV settingsInformation about the modem Modem configurationPosition of the RGB output User preferences Receiver upgradeReinstall Language preferencesAge rating control Parental controlReceiver lock Appearance preferences Receiver numberSystem information DiagnosticsSystem information Release infoTimer Conditional AccessViaccess embedded GeneralTimer settings Important information related to the timer settingsGlossary of Terms AGCProblem Solving Problem Possible causes What to doWhat to do if you can’t solve the problem Front Panel DisplayTechnical Specifications Security informationPage 0232