Nokia 9802 S owner manual Installation of the Mediamaster, Preparing the remote control

INSTALLATION OF THE MEDIAMASTER

The box for your Mediamaster should contain the following items:

• the Mediamaster
• remote control with 2 AAA batteries
• SCART cable (fully connected 1,0 metre)
• aerial/RF cable (double screened 1,5 metres)			RF cable
SCART cable
• owner’s manual and software license agreement
• mains cable
Remote	Owner’s manual		mains
control	License agreement		cable
About the SCART sockets
The rear panel of the Mediamaster is equipped with 2 SCART
sockets (see diagram). When you connect other devices to any
of these sockets, always use fully connected SCART cables (as
the one supplied.) There are SCART cables available which do not
have all the pins connected. The picture quality could be reduced		SCART socket
if you use them.

Preparing the remote control

•Remove the cover on the battery compartment at the bottom of the remote control.

•Insert the 2 AAA (1,5 V) batteries, as shown in the diagram, taking care to observe the + and - markings indicated inside.

•Replace the cover.

Connecting the Mediamaster to the dish

If you need to fit the F-connectors onto the cable

•Prepare each end of the cable as shown in the diagram. You will need to fold back the outer braid (as shown).

•Slide the F-connector onto the cable, then turn it clockwise until it grips the braid.

•Ensure that 3 mm of the core is protruding from the end of the connector.

Installing the satellite dish

•See the ”Fitting instructions for satellite dish” on how to in- stall the dish.

•Connect the coaxial cable, with F-connectors fitted, from the LNB on the satellite dish to the socket marked ”ANTENNA”on the rear panel of the Mediamaster.

GB 8

15 mm

8 mm

F-connector

3 mm