Dish Network DVR-7000 manual Connect a Dish

Page 12

Section 3 Installation

.

2.CONNECT A DISH

It is possible to connect the different dish configurations with the use of RF coaxial cables. Only the most common configurations are discussed. If in doubt, please ask the EchoStar service department for advice.

WARNING

ALL EQUIPMENT INVOLVED IN THE INSTALLATION TASK MUST BE INSTALLED CORRECTLY AND SWITCHED OFF. MAKE SURE THAT IT IS SAFE TO PROCEED WITH THE INSTALLATION TASK. UNSAFE CIRCUITS AND INSTALLATIONS CAN CAUSE (SERIOUS) INJURY OR DAMAGE TO EQUIPMENT.

CAUTION

Tighten the cable connectors only by hand. Do not use any tools. You will damage the connector pins if you overtighten the connector. This will result in loss of signal quality, or even total loss of reception.

1.On the dish installation, connect a RF cable (for detailed instructions, refer to the manufacturer’s instructions).

2.On the rear panel of the receiver find the LNB IN (digital), the IF OUT and the LNB IN ANALOG connectors.

FIXED DISH INSTALLATION WITH LNB(F)

3.Install the F-connector (dish) to the LNB IN connector (receiver).

4.Install the delivered loop through cable between the IF OUT connector (receiver) to the LNB IN ANALOG connector (receiver).

© 2002 EchoStar International Corporation All rights reserved

Page 3 - 2

EchoStar DVR-7000 Viaccess

Page 11 Page 13
Image 12
Page 11 Page 13
Contents DVR-7000 Viaccess Page Intended USE Warranty Dear CustomerDisclaimer Copyright and Trademarks Preface Index Appendix General Safety Electrical SafetySymbols Used on the Receiver Symbols on the Front PanelSymbols on the Rear Panel Contents of the BOX Storage and TransportTo Unpack Your Receiver Disposal of Your Packing MaterialsTo Setup Your Peripheral Equipment To Setup the ReceiverTerrestrial Antenna DishConnect Your Equipment Connect a Dish Fixed Dish Installation with Diseqc Switch To Setup Your Receiver for the First Time For Fixed and Diseqc 1..4 Switch Installations For signal verification For Motorized Installations Manual Selection For Smatv Installations Receiver Receiver Front PanelM2 connector spring-clip Receiver Rear PanelRemote Control Unit RCU RewindEchonav Installation Menu Echonav User InterfaceUser Preferences Menu User Profile LanguagesParental Lock Local Time TV SystemInstallation Setup Menu System Setup Menu LNB1Fixed Dish Setup Program SatellitesUser LNB Setting About EchostarSystem Upgrade Factory ResetCI Information Menu CI-MODULESEchonav Mode and Selection Menus IntroductionEdit Electronic Program Guide EPG SortTimers Infobanner and POP-UP Menus TV InfobannerRadio Infobanner DVR Infobanner MP3 InfobannerPOP-UP Menus SubtitleSatellite List To Select a Mode To Navigate Through the MenusTo Select a Channel To Select a List To Group a ListTo Sort a List To Edit a List To Move a ChannelTo Lock a Channel To SET the Channel Volume Offset To Delete a ChannelTo Rename a Channel or Recording To Hide a Channel USE the Favorite Lists ADD a Channel to a Favorite List ADD a Group of Channels to a Favorite ListRename a Favorite List To USE the Electronic Program Guide EPG To SET a Timer Change the repetition rate Use Key, to go to the Period Delete a Timer USE the Infobanner Related FunctionsTo Select the Alternate Audio To Select the Subtitle Language To Select Another SatelliteTo USE the DVR Play Back a RecordingUSE the Index Marker Play Back the Index MarkerUSE the A-B Marker Capture a Personal BackgroundInstall a Personal Background USE Live PauseTo USE the MP3 Player Play Back a SongTo SET the User Preferences To Change the User ProfileTo Change the Language To SET the Parental LockTo Change the PIN Code To SET the Local Date and Time To SET the TV SystemOperation Hardware Maintenance Software MaintenanceTo Change the Setup of the Receiver To Change the User LNB Settings About Echostar Receiver InformationTo do a Software Update from the Satellite To do a Factory ResetTo GET Conditional Access Information To ADD a SatelliteTo ADD a Transponder To ADD a PID END of Life Disposal Maintenance General EPG RelatedTV and Radio Related Remote Control Unit RCU Related DVR RelatedInstallation Related MP3 Player RelatedMind dish damage, revise Troubleshooting List of Used Abbreviations Min uteExplanation of Used Terminology CcittGlossary Explanation of the Search Modes Smart CardIndex Section Index LNB Configuration Matrix Lnbf Configuration MatrixUser Defined Lnbf Matrix Appendix 1 Lnbf Configuration matrix Introduction BatteriesKeys EchoStar DVR-7000 Viaccess Setup with USE of the Equipment Code List Program the TV, VCR and AUX KEYSpecial Setup Functions Setup with USE of the Search Code FeatureRead OUT the Equipment Code Setup a Second TV or VCR Undo the Setup of a Second TV or VCRVolume Lock Punch Through Reset Volume Lock Punch ThroughFactory Reset REAL-TIME MacrosTroubleshooting Full Factory ResetEquipment Codes Echostar Satellite ReceiversKEY KEY D2500 I.P AD2000 I.P SR200 I.P SR5500 LT7500 D2500 I.P AD2000 I.P SR200 I.P SR5500 LT7500 Miscelleneous Audio BPL RBM GEC Video Recorders ITV DVD

DVR-7000 specifications

The Dish Network DVR-7000 is a remarkable digital video recorder that revolutionized home entertainment during its time of release. With its user-friendly interface and state-of-the-art technology, the DVR-7000 allowed viewers to take control of their viewing experience like never before.

One of the main features of the DVR-7000 is its ability to record multiple programs simultaneously. Equipped with dual tuners, this device enables users to watch one show while recording another, ensuring they never miss their favorite content. This capability is particularly beneficial during peak viewing hours when multiple popular shows air concurrently.

In terms of storage, the DVR-7000 provides ample space for users to save their favorite programs. With a hard drive capacity of 120 gigabytes, it can store approximately 100 hours of standard-definition content, allowing binge-watchers and series enthusiasts to keep their favorite shows at their fingertips. This storage capacity also means less time spent managing recordings, as users can save more content before needing to delete anything.

The DVR-7000 boasts advanced playback features, allowing users to pause, rewind, and fast-forward live television. This functionality empowers viewers to take breaks during their programs and catch up later without missing any crucial moments. Additionally, the device supports features like Instant Replay, which allows users to quickly re-watch a specific segment of a show.

Connectivity is another key characteristic of the DVR-7000. The device includes multiple outputs, including HDMI and component video, ensuring compatibility with modern televisions. Its Ethernet port also allows users to connect to the internet, providing access to Dish Network’s On Demand content, enabling users to stream a variety of movies and shows at their leisure.

The user interface of the DVR-7000 is designed for ease of navigation, featuring an intuitive electronic programming guide (EPG). This guide allows users to explore program listings, set recordings, and access additional information about shows with minimal effort.

Overall, the Dish Network DVR-7000 showcases significant advancements in the realm of home entertainment technology. Its discending features, robust storage options, and user-friendly interface helped to enhance the viewing experiences of countless households. Despite the continued evolution of DVR technology, the DVR-7000 remains a notable device in the annals of home entertainment history.
Top Page Image Contents