Dish Network DVR-7000 manual General Safety, Electrical Safety

Page 7

EchoStar International Corporation

All rights reserved

© 2002

 

Safety Information Section 1

1. GENERAL SAFETY

1

Read this manual carefully and make sure you understand the instructions given. For your

safety, know what the reaction upon each action will be. Do not perform any actions which are not described in this manual, failing to do so might result in an uncontrolled behavior of the receiver or even in a hazardous situation for persons and/or equipment.

Disconnect the receiver from the mains before you start any maintenance or installation procedures. Do not use alcohol or ammonia based liquids to clean the receiver. If required, clean with a soft lint-free cloth slightly made damp with a mild soap solution.

Consult an authorized service technician if the receiver does not operate normally when the instructions in this user manual are strictly followed. Do not to attempt to open the receiver, as you will be exposed to a shock hazard.

Do not put any objects on top of the receiver which could fall through the ventilation slots or which could cover them and prevent proper cooling of the components inside.

Do not put any (foreign) objects into the ventilation or CI-slots. This can cause fire or an electrical shock by shorting the internal components.

Make sure that nothing rests on the receivers cables and that the cables are not located where they can cause injury to persons and pets (e.g to stumble over, eat the cable).

Do not install the receiver:

■ in a closed or poorly ventilated cabinet;

■ directly on top of or under another equipment;

■ on a surface which will obstruct the ventilation slots. Do not expose the receiver and it’s accessories:

■ to rain or excessive moisture to avoid the risk of shock or permanent damage to your receiver;

■ to direct sunlight, heaters, stoves or any other heat generating equipment;

■ to any magnetic objects, such as speakers, electric motors, transformers, etc.; ■ to excessive vibration.

To help avoid possible damage to the receiver’s electronics:

■wait 5 seconds after you switched off the receiver before you move the receiver or discon- nect any equipment;

■do not touch the components or pins on the CI-module or the smart card and hold the CI-module and the smart card by it’s edges.

2.ELECTRICAL SAFETY

When using or connecting electrical equipment always observe the safety regulations applicable in your country to reduce the risk of fire, electrical shock, and personal injury.

Read and comply at least with the given safety instructions.

■Always make sure that the electrical power supply corresponds with the voltage on the electrical identification plate at the rear of the receiver next to the electrical cord.

■Your receiver is double insulated and complies with the EN 50144; therefore no additional earth wire is required, though the use of an earth leak switch and/or over voltage protec- tion switch is recommended.

■Only use an approved extension (convenience) lead suitable for the electrical power con- sumption of the installed equipment.

Digital Satellite Receiver

Page 1 - 1

Page 6 Page 8
Image 7
Page 6 Page 8
Contents DVR-7000 Viaccess Page Dear Customer Intended USE WarrantyDisclaimer Copyright and Trademarks Preface Index Appendix Electrical Safety General SafetySymbols on the Front Panel Symbols Used on the ReceiverSymbols on the Rear Panel Disposal of Your Packing Materials Contents of the BOXStorage and Transport To Unpack Your ReceiverDish To Setup Your Peripheral EquipmentTo Setup the Receiver Terrestrial AntennaConnect Your Equipment Connect a Dish Fixed Dish Installation with Diseqc Switch To Setup Your Receiver for the First Time For Fixed and Diseqc 1..4 Switch Installations For signal verification For Motorized Installations Manual Selection For Smatv Installations Receiver Front Panel ReceiverReceiver Rear Panel M2 connector spring-clipRewind Remote Control Unit RCUEchonav User Interface Echonav Installation MenuUser Preferences Menu Languages User ProfileParental Lock TV System Local TimeInstallation Setup Menu LNB1 System Setup MenuProgram Satellites Fixed Dish SetupAbout Echostar User LNB SettingFactory Reset System UpgradeCI-MODULES CI Information MenuIntroduction Echonav Mode and Selection MenusEdit Sort Electronic Program Guide EPGTimers TV Infobanner Infobanner and POP-UP MenusRadio Infobanner MP3 Infobanner DVR InfobannerSubtitle POP-UP MenusSatellite List To Navigate Through the Menus To Select a ModeTo Select a Channel To Group a List To Select a ListTo Sort a List To Move a Channel To Edit a ListTo Lock a Channel To Delete a Channel To SET the Channel Volume OffsetTo Rename a Channel or Recording To Hide a Channel USE the Favorite Lists ADD a Group of Channels to a Favorite List ADD a Channel to a Favorite ListRename a Favorite List To USE the Electronic Program Guide EPG To SET a Timer Change the repetition rate Use Key, to go to the Period USE the Infobanner Related Functions Delete a TimerTo Select the Alternate Audio Play Back a Recording To Select the Subtitle LanguageTo Select Another Satellite To USE the DVRPlay Back the Index Marker USE the Index MarkerCapture a Personal Background USE the A-B MarkerUSE Live Pause Install a Personal BackgroundPlay Back a Song To USE the MP3 PlayerTo Change the User Profile To SET the User PreferencesTo SET the Parental Lock To Change the LanguageTo Change the PIN Code To SET the TV System To SET the Local Date and TimeOperation Software Maintenance Hardware MaintenanceTo Change the Setup of the Receiver About Echostar Receiver Information To Change the User LNB SettingsTo do a Factory Reset To do a Software Update from the SatelliteTo ADD a Satellite To GET Conditional Access InformationTo ADD a Transponder To ADD a PID END of Life Disposal Maintenance EPG Related GeneralTV and Radio Related DVR Related Remote Control Unit RCU RelatedMP3 Player Related Installation RelatedMind dish damage, revise Troubleshooting Min ute List of Used AbbreviationsCcitt Explanation of Used TerminologyGlossary Smart Card Explanation of the Search ModesIndex Section Index Lnbf Configuration Matrix LNB Configuration MatrixUser Defined Lnbf Matrix Appendix 1 Lnbf Configuration matrix Batteries IntroductionKeys EchoStar DVR-7000 Viaccess Program the TV, VCR and AUX KEY Setup with USE of the Equipment Code ListSetup with USE of the Search Code Feature Special Setup FunctionsRead OUT the Equipment Code Reset Volume Lock Punch Through Setup a Second TV or VCRUndo the Setup of a Second TV or VCR Volume Lock Punch ThroughREAL-TIME Macros Factory ResetFull Factory Reset TroubleshootingEchostar Satellite Receivers Equipment CodesKEY KEY D2500 I.P AD2000 I.P SR200 I.P SR5500 LT7500 D2500 I.P AD2000 I.P SR200 I.P SR5500 LT7500 Miscelleneous Audio BPL RBM GEC Video Recorders ITV DVD

DVR-7000 specifications

The Dish Network DVR-7000 is a remarkable digital video recorder that revolutionized home entertainment during its time of release. With its user-friendly interface and state-of-the-art technology, the DVR-7000 allowed viewers to take control of their viewing experience like never before.

One of the main features of the DVR-7000 is its ability to record multiple programs simultaneously. Equipped with dual tuners, this device enables users to watch one show while recording another, ensuring they never miss their favorite content. This capability is particularly beneficial during peak viewing hours when multiple popular shows air concurrently.

In terms of storage, the DVR-7000 provides ample space for users to save their favorite programs. With a hard drive capacity of 120 gigabytes, it can store approximately 100 hours of standard-definition content, allowing binge-watchers and series enthusiasts to keep their favorite shows at their fingertips. This storage capacity also means less time spent managing recordings, as users can save more content before needing to delete anything.

The DVR-7000 boasts advanced playback features, allowing users to pause, rewind, and fast-forward live television. This functionality empowers viewers to take breaks during their programs and catch up later without missing any crucial moments. Additionally, the device supports features like Instant Replay, which allows users to quickly re-watch a specific segment of a show.

Connectivity is another key characteristic of the DVR-7000. The device includes multiple outputs, including HDMI and component video, ensuring compatibility with modern televisions. Its Ethernet port also allows users to connect to the internet, providing access to Dish Network’s On Demand content, enabling users to stream a variety of movies and shows at their leisure.

The user interface of the DVR-7000 is designed for ease of navigation, featuring an intuitive electronic programming guide (EPG). This guide allows users to explore program listings, set recordings, and access additional information about shows with minimal effort.

Overall, the Dish Network DVR-7000 showcases significant advancements in the realm of home entertainment technology. Its discending features, robust storage options, and user-friendly interface helped to enhance the viewing experiences of countless households. Despite the continued evolution of DVR technology, the DVR-7000 remains a notable device in the annals of home entertainment history.
Top Page Image Contents