Dish Network DVR-7000 manual Fixed Dish Setup, Program Satellites

Page 28

Section 4 Familiarization

2.2.2.FIXED DISH SETUP

This sub menu allows you to customize the system setup to add an additional fixed dish into your motorized configuration. Note that the menu page is dynamic which means that it changes with the selections you make. You can customize:

■LNBs

To set the amount of LNBs you have installed.

■Polarity

To set the device that controls the signal polarity.

■Switch

To set the switch type which you use to control the dish installation.

■LNB1

To set the LNB type(s) you use.

■Satellite

To set the satellite you want to scan for the LNB.

■Check Signal

To confirm the selections you made and advance to the Check Signal page.

2.2.3.PROGRAM SATELLITES

This sub menu allows you to customize the system setup to add an additional satellite into your receiver. Note that the menu page is dynamic which means that it changes with the selections you make. You can customize and view:

■Satellite

To set the satellite you want to scan for the LNB.

■Search mode

To set a specific search mode (All, FTA, IF, TP, network or update).

■Longitude

To view the satellite location on the Clarke Belt.

■Transponder

To select a transponder of the selected satellite.

■Skew

To adjust the Horizontal/Vertical setting (only for polarotor).

■Location

To move the dish for best signal level and quality.

■Satellite offset

To compensate for a dish offset caused by ambient

conditions.

NOTE

The satellite offset will affect all satellite positions, this means that all scanned positions will change which might result in total loss of signal for all satellites.

■Search Channels

To confirm the selections you made and advance to the Search Channels page.

© 2002 EchoStar International Corporation All rights reserved

Page 4 - 10

EchoStar DVR-7000 Viaccess

Page 27 Page 29
Image 28
Page 27 Page 29
Contents DVR-7000 Viaccess Page Dear Customer Intended USE WarrantyDisclaimer Copyright and Trademarks Preface Index Appendix General Safety Electrical SafetySymbols on the Front Panel Symbols Used on the ReceiverSymbols on the Rear Panel Contents of the BOX Storage and TransportTo Unpack Your Receiver Disposal of Your Packing MaterialsTo Setup Your Peripheral Equipment To Setup the ReceiverTerrestrial Antenna DishConnect Your Equipment Connect a Dish Fixed Dish Installation with Diseqc Switch To Setup Your Receiver for the First Time For Fixed and Diseqc 1..4 Switch Installations For signal verification For Motorized Installations Manual Selection For Smatv Installations Receiver Receiver Front PanelM2 connector spring-clip Receiver Rear PanelRemote Control Unit RCU RewindEchonav Installation Menu Echonav User InterfaceUser Preferences Menu Languages User ProfileParental Lock Local Time TV SystemInstallation Setup Menu System Setup Menu LNB1Fixed Dish Setup Program SatellitesUser LNB Setting About EchostarSystem Upgrade Factory ResetCI Information Menu CI-MODULESEchonav Mode and Selection Menus IntroductionEdit Electronic Program Guide EPG SortTimers TV Infobanner Infobanner and POP-UP MenusRadio Infobanner DVR Infobanner MP3 InfobannerSubtitle POP-UP MenusSatellite List To Navigate Through the Menus To Select a ModeTo Select a Channel To Group a List To Select a ListTo Sort a List To Edit a List To Move a ChannelTo Lock a Channel To Delete a Channel To SET the Channel Volume OffsetTo Rename a Channel or Recording To Hide a Channel USE the Favorite Lists ADD a Channel to a Favorite List ADD a Group of Channels to a Favorite ListRename a Favorite List To USE the Electronic Program Guide EPG To SET a Timer Change the repetition rate Use Key, to go to the Period USE the Infobanner Related Functions Delete a TimerTo Select the Alternate Audio To Select the Subtitle Language To Select Another SatelliteTo USE the DVR Play Back a RecordingUSE the Index Marker Play Back the Index MarkerUSE the A-B Marker Capture a Personal BackgroundInstall a Personal Background USE Live PauseTo USE the MP3 Player Play Back a SongTo SET the User Preferences To Change the User ProfileTo SET the Parental Lock To Change the LanguageTo Change the PIN Code To SET the Local Date and Time To SET the TV SystemOperation Software Maintenance Hardware MaintenanceTo Change the Setup of the Receiver To Change the User LNB Settings About Echostar Receiver InformationTo do a Software Update from the Satellite To do a Factory ResetTo GET Conditional Access Information To ADD a SatelliteTo ADD a Transponder To ADD a PID END of Life Disposal Maintenance General EPG RelatedTV and Radio Related Remote Control Unit RCU Related DVR RelatedInstallation Related MP3 Player RelatedMind dish damage, revise Troubleshooting List of Used Abbreviations Min uteExplanation of Used Terminology CcittGlossary Explanation of the Search Modes Smart CardIndex Section Index Lnbf Configuration Matrix LNB Configuration MatrixUser Defined Lnbf Matrix Appendix 1 Lnbf Configuration matrix Batteries IntroductionKeys EchoStar DVR-7000 Viaccess Setup with USE of the Equipment Code List Program the TV, VCR and AUX KEYSetup with USE of the Search Code Feature Special Setup FunctionsRead OUT the Equipment Code Setup a Second TV or VCR Undo the Setup of a Second TV or VCRVolume Lock Punch Through Reset Volume Lock Punch ThroughFactory Reset REAL-TIME MacrosTroubleshooting Full Factory ResetEquipment Codes Echostar Satellite ReceiversKEY KEY D2500 I.P AD2000 I.P SR200 I.P SR5500 LT7500 D2500 I.P AD2000 I.P SR200 I.P SR5500 LT7500 Miscelleneous Audio BPL RBM GEC Video Recorders ITV DVD

DVR-7000 specifications

The Dish Network DVR-7000 is a remarkable digital video recorder that revolutionized home entertainment during its time of release. With its user-friendly interface and state-of-the-art technology, the DVR-7000 allowed viewers to take control of their viewing experience like never before.

One of the main features of the DVR-7000 is its ability to record multiple programs simultaneously. Equipped with dual tuners, this device enables users to watch one show while recording another, ensuring they never miss their favorite content. This capability is particularly beneficial during peak viewing hours when multiple popular shows air concurrently.

In terms of storage, the DVR-7000 provides ample space for users to save their favorite programs. With a hard drive capacity of 120 gigabytes, it can store approximately 100 hours of standard-definition content, allowing binge-watchers and series enthusiasts to keep their favorite shows at their fingertips. This storage capacity also means less time spent managing recordings, as users can save more content before needing to delete anything.

The DVR-7000 boasts advanced playback features, allowing users to pause, rewind, and fast-forward live television. This functionality empowers viewers to take breaks during their programs and catch up later without missing any crucial moments. Additionally, the device supports features like Instant Replay, which allows users to quickly re-watch a specific segment of a show.

Connectivity is another key characteristic of the DVR-7000. The device includes multiple outputs, including HDMI and component video, ensuring compatibility with modern televisions. Its Ethernet port also allows users to connect to the internet, providing access to Dish Network’s On Demand content, enabling users to stream a variety of movies and shows at their leisure.

The user interface of the DVR-7000 is designed for ease of navigation, featuring an intuitive electronic programming guide (EPG). This guide allows users to explore program listings, set recordings, and access additional information about shows with minimal effort.

Overall, the Dish Network DVR-7000 showcases significant advancements in the realm of home entertainment technology. Its discending features, robust storage options, and user-friendly interface helped to enhance the viewing experiences of countless households. Despite the continued evolution of DVR technology, the DVR-7000 remains a notable device in the annals of home entertainment history.
Top Page Image Contents