Kathrein UFD 515 manual Command of remote control

Command of remote control

	The remote control features 2 command sets, making it possible to
	operate 2 receivers independently of each other in one room (not
	together with a twin receiver).
Note	For this purpose, program one receiver on the command set 1 and the
	second receiver on the command set 2.
	Switch on receiver 1 and receiver 2 off with the mains switch
	Press and hold the ￿button.
	Enter "901" with the number buttons.
	To adopt the code, press the ￿button to switch receiver 1 to
	standby and then switch off the device with the mains switch.
	Put receiver 2 into operation again.
	Press and hold the ￿button.
	Enter "902" with the number buttons.
	To adopt the code, press the ￿ button to switch receiver 2 to
	standby and then back into operation. Now switch on receiver 1 again.
	Press and hold the ￿button.
	Enter "903" with the number buttons.
	When carrying out the first two settings, the remote control must be
	directed at the respective receiver (when switched on).
	By pressing the ￿button, you can now switch between the two
	command sets A and B (toggle function) and alternately operate both
	receivers.
	Command set 1 is always active as the on-delivery setting.
	If you are operating only one receiver and the active command set is
	switched over by mistake so that this receiver can no longer be
	operated, the remote control can be easily switched back to command
	set 1. The procedure is already described above.

11