Kathrein UFD 515 manual Switching off sound

Page 31

Sound settings

In order to reproduce the AC3 format, set your receiver to “2 of 2" or "2 of 2 (2ch)" in the audio menu under "Stereo." The corresponding transmission – "5.1 Ch" (5 channels + 1 subwoofer channel) is then indicated at “Dig. output”.

Only a few programme providers broadcast the AC3 format. As long as no AC3 signal is received, you can only carry out the usual stereo and mono settings or select the transmitted language.

Switching off sound

Press the ￿button on the remote control to mute the sound. This symbol ￿appears on the screen.

Press the ￿button again to restore the sound. The standard volume display bar is then shown for several seconds.

Even though you can change the programme while in mute mode, it will remain muted until this mode is cancelled or you correct the volume.

31

Image 31
Contents Operating manual Page Important notes PrefaceContents Transponder selection DiSEqC Repeat Safety instructions Mains voltage Place of installationVentilation Humidity, exposure to sunlight, heatView of front panel Controls, displays and connectionsView of rear panel Remote control handset keys Command of remote control Menu concept Operating instructionsButton functions Alphanumeric entries Language selection- OSD Connection and start-up Connecting receiverPreconditions for receiving signals Presetting of receiving systemAudio connection Inserting batteries in the remote controlLNB supply voltage TV and video recorder connectionFactory setting of receiver First time installationFirst steps Important screen displays On screen displays / OSDHelp function TV channel identifier Error messageRadio channel identifier Teletext Programme list Radio/TVSelecting a TV programme Programme selectionReception status Programme selection Selecting a TV programme by number entry Switching to a radio programmeReception status radio Selecting a radio programme by number entry Observe the operating manual of your Pay-TV provider Common InterfaceCommon Interface Common Interface Timer settings VPS signal Setting the volume Sound settingsStereo and two-channel sound reproduction Switching off sound Selecting programmes last received Programme listFavourite programmes Programme list Programme list Programme list Programme list Search programme alphabetically Sorting programmes Deleting programme Manually adding programmes Be careful when deleting programmesProgramme list Adding and removing satellites Setting up a satelliteRemoving a satellite Entering a satellite nameEPG Programme overviewEPG timer programming Factory setting PasswordEntering a password Password Parental lock Password Operation from front panel Backup operationSetting system parameters System information System parametersScreen Local time/TimerTV type Picture formatLNB configuration Installation menuMode Oscillator frequency L.O Standby Antenna rotor / Positioner DiSEqC Antenna settingsSatellite search Setting system parameters Transponder selection TP set-up/searchAll new programmes are added to the existing programme list DiSEqC UFO Set-up KH signalTone burst Pre-programming is not deleted with Reset Recording Video recorder connectionPlayback Software and programme list update Software and programme list update „Display info Transferring operating software Data transfer from receiver to receiverPreparation Transferring programme listsTechnical annex Technical featuresRF features Technical dataSwitch-over VHS/S-VHS AccessoriesScart socket assignments Connection arrangement Connection examplesTechnical annex DiSEqC Short technical lexiconTransponder GlossarySatellite ServiceDiSEqC menu ZWT Technische Änderungen vorbehalten