
First time installation
The first steps
Connect the receiver to the mains power supply.
Switch on the receiver by pressing the power button on the front of the unit.
The display, "- - -
When the LED for the operating display is red, the television is in standby.
Switch on the receiver by pressing the button on the remote control.
The orange LED on the front panel of the receiver flashes every time a button on the remote control is pressed.
You will see the factory set programme on your TV screen. An information bar indicating the programme provider, the time, the timer settings, the programme status and the programme title will be displayed in the bottom section of the screen, provided the corresponding data are transmitted. The number of the programme memory appears in the LED display.
The red standby indicator goes out.
You can now receive the factory set TV and radio programme and select it by pressing the buttons. Press the and
buttons to select radio programmes. Press the or button to return to TV programmes.
Refer to the section " Programme lists – TV/radio" for information on how to set up and save other TV and radio programmes.
The reception status last set always reappears when the receiver is switched on.
Please check the time of day for summer or winter.
If the message "bad or no signal" appears on the screen in addition to an
In this case, first check the connection configuration and then check whether the basic settings of you receiver are correct for your system. If necessary, have a specialist do this for you.
Factory setting of receiver
Your receiver is
Before you change the basic settings of your receiver, note down the settings in the form provided at the end of this operating manual. You will then be able to restore the original settings at any time.
17