Receiver operation
Note | With the setting “2- or |
| programme after approximately 3 seconds. Digits can be entered during this time. |
| With the setting “free entry“ (in the above example) the receiver switches to the |
| corresponding programme slot immediately after each input. |
| In the initial setup menu, a continuous |
| be selected (see section: “Initial settings, On Screen Displays“). |
Adjusting volume, balance and tone
∙Use the keys to adjust the volume to the desired level.
The volume is adjustable in 21 steps. The volume level set appears on the LED display for approximately 3 seconds. At the same time a bar indicator appears on the screen.
Note | The settings are not operative on the VCR Scart socket in order not to disturb any | ||
| recordings. | ||
| The | ||
| Whilst the menu for volume adjustment is overlaid, the |
| key can be used to acti- |
|
| ||
| vate the following menu for balance adjustment, tone adjustment, stereo width and | ||
|
| Using the | keys or the |
| key you can select the particular menu entry and |
|
| |||
| then make changes with the | keys. | ||
Note | In the menu entry “Stereo Width" the stereo base width can be adjusted independ- | |||
| ently. |
|
|
|
|
grammes, and should thus only be activated with mono reception.
If
Muting the sound
∙Press the key.
| The sound is muted, allowing you to make a phone call undisturbed, for example. | ||
| In the LED display the sound muting is shown by means of 3 dots. | ||
|
| ||
Note | ∙ Press the |
| key again to turn the sound back on. |
| |||
Mute is not operative at the VCR Scart socket. |
11