Video menu, Polarisation/Oscillator | Kathrein UFD 400 specs

Programming TV programmes

∙Call up the audio menu: press keys + in succession.

∙Switch between video and audio menus using the key or the key.

∙Select the desired menu line using the keys .

∙For direct numeric input use the keys ...

	or
	∙	Alter the values step-by-step using the			keys.
	∙	Press the	key twice in order to save your settings.
	∙
Note		Exit from the menu with the		key.
		Exit from the menu with the		key.
	Frequent reference is made to saving the settings in subsequent descriptions. It is
	always sufficient, however, if you save the settings in the video and audio menus
	just once before exiting from the programme slot or before exiting from setup
	mode.

The "Video" menu

The following settings can be made in the video menu:

Setting option: Programme slot 1 to 250

5-character station identifier

Transmission freq. from 10700...12747 MHz Hor Low / Vert Low / Hor High / Vert High 1 to 4

16 or 25 MHz LO 1 to LO 4

See separate decoder menu

The bottom line shows the keys you can use to make the settings.

Description of menu entries

Satellite frequency

With input via the numeric keys ... frequency input is in 5-figure form in the

range 10700 to 12747 MHz. With the keys you can attain the optimum receiv- ing frequency by moving in 1 MHz steps (recommended if the picture is grainy due to weak signals).

Polarisation/Oscillator

In menu entry “Polarisation“, the voltage level is used (14 or 18V) to set the polarity (vertical or horizontal).

In the “Oscillator" menu entry, the oscillator frequency group LO 1 to LO4 is se- lected. With the oscillator frequency the high satellite frequency is converted to the satellite IF frequency. This allows troublefree matching to different feed systems.

Frequency range	Polarisation	LNB-	Setting	LO-	LO-
		voltage		group	frequency
10.70 – 11.70 GHz	horizontal	18 V	Hor Low	LO 1	9750 MHz
10.70 – 11.70 GHz	vertical	14 V	Vert Low	LO 2	9750 MHz
11.70 – 12.75 GHz	horizontal	18 V	Hor High	LO 3	10600 MHz
11.70 – 12.75 GHz	vertical	14 V	Vert High	LO 4	10600 MHz

For setting of LO frequencies refer to section: “Initial setting".