Kathrein UFD 400 manual Safety instructions, Important notes regarding operation

Page 5

Safety instructions

The following section contains important information relating to operation, place of installation and connecting-up of the receiver.

Read these notes carefully before putting the unit into operation.

Important notes regarding operation

Extended absence / Thunderstorms

Always switch the unit off via its mains switch during periods of extended absence or at the onset of thunderstorms. This also applies to any other equipment atta- ched.

However, take account of any possible timer programming, and switch the unit on again in good time prior to the recording time.

Mains lead

Make certain that the mains lead (power supply lead) is undamaged. Never put the unit into operation if the mains lead is damaged.

Cleaning

Withdraw the mains plug before cleaning the unit. Use a dry cloth for cleaning.

Children-at-play

Pay attention that children do not insert objects into the ventilation slots. There is a risk of mortal danger due to electric shock.

Repairs

On no account remove the housing cover since there are dangerous voltages in- side the unit that may be contacted. The unit must only be opened by qualified specialists, so allow them to carry out any repairs or adjustments to your receiver. Unauthorised opening entails loss of guarantee.

The electrical safety of the unit can be affected by improper tampering with it.

The manufacturer‘s liability excludes accidents occurring to the user when the unit is opened.

5

Image 5
Contents Kathrein Satellite Receiver UFD Contents Controls, displays and connections Rear panel controls and connections Remote control handset keysFront panel controls and displays Important notes regarding operation Safety instructionsImportant notes for siting and installation Connecting up the unit Connecting up and putting into operationSatellite signal connection Receiving system presetsUHF connection Inserting batteries into remote control handsetAudio connection Decoder connectionExternal infrared sensor Tuning UHF channel / Checking operationSwitchover between TV and radio mode Switching the unit onReceiver operation Selecting a programmeMuting the sound Adjusting volume, balance and toneMaking the settings Setting date and timeStereo- / Mono- / Channel changeover SAT/TV changeoverTimer setting Making changes Daily and weekly repeated switch-onVideo recorder playback VCR Programme sorting inserting, swapping and copying Switching back to last programme swappingDisplaying programme overview Operation without remote controlStop-watch Info menuProgramming TV programmes Tuning in TV programmesPolarisation/Oscillator Video menuDescription of menu entries Satellite frequency Decoder menu Orbit PositionVideo deviation Audio menu Audio modeProgramme name Saving the settings Volume offsetAudio carrier frequency Audio de-emphasis for sound type Mono wide onlyRadio menu Tuning in radio programmesProgramming radio programmes Modulator-output channel Initial settingsCalling the initial setup menu LNB supply voltage OSD languageLNB supply voltage in standby Programme selectionChanging the oscillator frequency Oscillator frequencyDiSEqC menu KHz signalSetting options in the DiSEqC menu Tone burst Tone burst and DiSEqC signalDiSEqC DiSEqC repeatUFO micro Switching over remote control’s command setRemote frequency Initial settings Features Specifications Accessories Temperature rangeScart socket assignments GeneralConnection examples / Service note 935.2122/E/1/05.99/SKS/PF Subject to alterations