Initial settings
| In the initial setup menu, matching of the satellite receiver to the satellite receiving |
| system is carried out. |
Important | The receiver has already been factory |
| ceiving systems. |
| Alterations to the initial setting are therefore necessary only if your receiving sys- |
| tem deviates from this type of installation or if you happen to want different set- |
| tings. |
| The settings in the initial setup menu are generally carried out by the specialist |
| dealer on installation of the satellite receiving system. |
| To prevent any unintentional alterations in the initial settings, the initial setup menu |
| can be invoked only from the |
Calling the initial setup menu
∙Switch the unit into standby.
∙Press both the programme selection buttons (2) 
on the receiver si- multaneously and keep them pressed.
∙ Switch the unit on via the key on the remote control.
∙Release the 
buttons when “C 38“ appears on the LED display.
C 38 is the factory preset UHF output channel. If the UHF channel has already been altered, the appropriate channel selection appears
(between Ch. 21 and Ch. 69).
The initial setup menu is displayed.
Setting option:
Modulator: channel 21 to 69
OSD language: bilingual German / English
LNB supply voltage: Off / On
LNB power supply in standby: Off / On
Programme selection:
OSD: Off / On (can be set individually for TV and radio)
Type of remote control: 26 or 24 keys.
Oscillator menu: LO 1 to LO 4 DiSEqC menu:
See separate menu in section “DiSEqC"
The bottom line shows the keys you can use to make the settings.
Settings are made in the initial setup menu in the same manner as in the other menus for the station programming:
∙Select menu entries with the 
keys.
∙Carry out settings and call up submenus with the 
keys (and use numeric keys 
..
on inputting frequency).
∙Press the 
key twice to save your settings.
∙Return with the 
key.
Modulator-output channel
The modulator‘s UHF output channel can be entered in the range from channel 21 to 69.
Default: channel “38“
23