Kathrein UFD 400 manual Controls, displays and connections

Page 3

Controls, displays and connections

This section contains a brief description of all the control elements, displays and connections. The key symbols presented here are also used when describing the operating sequences.

View of front panel

View of rear panel

Remote control handset

Image 3

Contents Kathrein Satellite Receiver UFD Contents Controls, displays and connections Remote control handset keys Front panel controls and displaysRear panel controls and connections Important notes regarding operation Safety instructionsImportant notes for siting and installation Receiving system presets Connecting up and putting into operationConnecting up the unit Satellite signal connectionDecoder connection Inserting batteries into remote control handsetUHF connection Audio connectionExternal infrared sensor Tuning UHF channel / Checking operationSelecting a programme Switching the unit onSwitchover between TV and radio mode Receiver operationMuting the sound Adjusting volume, balance and toneSAT/TV changeover Setting date and timeMaking the settings Stereo- / Mono- / Channel changeoverTimer setting Daily and weekly repeated switch-on Video recorder playback VCRMaking changes Programme sorting inserting, swapping and copying Switching back to last programme swappingInfo menu Operation without remote controlDisplaying programme overview Stop-watchProgramming TV programmes Tuning in TV programmesVideo menu Description of menu entries Satellite frequencyPolarisation/Oscillator Orbit Position Video deviationDecoder menu Audio mode Programme nameAudio menu Audio de-emphasis for sound type Mono wide only Volume offsetSaving the settings Audio carrier frequencyTuning in radio programmes Programming radio programmesRadio menu Initial settings Calling the initial setup menuModulator-output channel Programme selection OSD languageLNB supply voltage LNB supply voltage in standbyChanging the oscillator frequency Oscillator frequencyKHz signal Setting options in the DiSEqC menuDiSEqC menu DiSEqC repeat Tone burst and DiSEqC signalTone burst DiSEqCSwitching over remote control’s command set Remote frequencyUFO micro Initial settings Features Specifications General Temperature rangeAccessories Scart socket assignmentsConnection examples / Service note 935.2122/E/1/05.99/SKS/PF Subject to alterations