Kathrein UFD 400 manual Initial settings

Initial settings

	switch the receiver off using the mains switch					on the unit.
	∙ Set receiver 2 back into operation.
	⇒ Press the		key and keep it pressed.
	⇒ Using the numeric keys			...	enter “902“.
	∙ To adopt the code switch receiver 2 into standby using the						key, and then
	back into operation again. Set receiver 1 back into operation as well.
	⇒ Press the		key and keep it pressed.
Note	⇒ Using the numeric keys			...	enter “903“.
	With the first two settings the remote control must be pointer towards the respec-
	tive receiver which is switched on.
	With the	key you can now switch between the two command sets A and B (tog-
	gle function) and operate the two receivers in alternation.
	On delivery command set 1 is always active.
Note	If you are using only one receiver and the active command set has been switched
	over inadvertently due to maloperation rendering the receiver inoperable, the re-
	mote control can be switched back to command set 1 without difficulty. The proce-
	dure for this has already been described above.
Note	With remote control handsets that have 24 keys (remote controls of the 200-series
	receivers from Kathrein) code numbers 001, 002 and 003 are to be entered in
	place of codes 901, 902 and 903.

29