Initial settings
Tone burst
In the “Tone burst“ menu entry the following settings of the 22 kHz signal are pos- sible:
Switching states on setting:
Switching states on setting:
Switching states on setting:
22 kHz signal | High/Low and |
| 22 kHz signal | Pos. A/B and |
| 22 kHz signal | Pos. A/B and | ||||||||
Tone burst | Pos. A/B: |
| Tone burst |
| Opt. A/B |
| Tone burst | High/Low | |||||||
|
|
|
|
|
|
|
|
|
|
|
| ||||
Low |
| 22 kHz | Off |
| Pos | Tone burst | 22 kHz |
| Low | Tone burst | 0 | ||||
High |
| 22 kHz | On |
|
|
|
|
|
|
| High | Tone burst | 1 | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Pos. 1 Pos. 2
Tone burst Tone burst
0
1
1
2
3
4
0
0
1
1
Off
On
Off
On
Pos. 1 Pos. 2
22kHz
22kHz
Off On
DiSEqC
| Up to 16 inputs can be switched with the “DiSEqC“ control signal. |
| If the receiver is connected up to a “DiSEqC" |
| must be set to “On” . |
| Default: OFF |
Note | For optimal usage it is essential to know the switching criteria and the input as- |
| signments of the DiSEqC switching matrices. |
| Thus take into account the specifications of the DiSEqC switching matrices or get |
| in touch with the installer of the receiving system. |
DiSEqC Repeat
If the receiver is operated on a receiving system with two or more DiSEqC switch- ing matrices connected in series (cascaded), the DiSEqC command must be re- peated.
∙ In this case set the menu entry “DiSEqC Repeat" to “1" or “2“. Default: Off
UFO mini
| With a |
| is adjusted to a fixed input frequency. The signals are transmitted by the “sub- |
| |
| rameters for the programme selection are transmitted by “DiSEqC“ command |
| to the receiving system and set up there. |
| Which setting needs to be selected "On", “UFO twin 1“ or “ UFO twin 2“ is depend- |
| ent on the design of the |
| The “UFO mini Twin“ design is a special form of the |
| processing system“ |
Note | The setting is therefore to be made according to information in the “subscriber- |
| controlled preprocessing system“ installation guide. |
Remote frequency
| If you have set "On" or “UFO twin 1“ in menu entry UFO mini, make the setting in |
| this menu entry for the transmission frequency. |
| The particular transmission frequency that needs to be set in the range 0 to 2150 |
| MHz, is given in the |
| guide. |
Note | It is therefore essential to note the installation guide instructions of the “subscriber- |
| controlled preprocessing system“. |
32