Kathrein UFD 430 manual External infrared sensor

Connecting up and putting into operation

Tuning UHF channel / Checking operation

∙Switch on the satellite receiver via the on/off switch on the front of the unit. The LED display on the unit shows the last programme slot that was selected.

∙Turn on your TV set.

∙If the satellite receiver and TV set are connected up via a Scart cable, tune in an audio-visual (AV) programme slot on the TV set.

∙With UHF connection via coaxial cable, set up your TV to UHF channel 38 (sat- ellite receiver‘s factory-preset channel) at a spare programme position.

Also take note of instructions in TV set‘s operating manual!

Note	If channel 38 is occupied by a terrestrial broadcast programme or the video re-
	corder, adjust your TV set to a spare UHF channel in the range 21 to 69.

∙To avoid interference, when setting the UHF output channel try to ensure that there is at least one free channel above and below the channel.

∙For tuning of UHF output channel at the satellite receiver refer to "Modulator" in section: "Initial setting".

You can now receive the factory-preset TV and radio programmes. To find out how to tune in additional TV and radio programmes, refer to sections: “Programming TV programmes“ and “Programming radio programmes“.

External infrared sensor

If the receiver is to be operated from a location that cannot be reached using the remote control handset, (with attachment of a further stereo system in another room, for example), the URS 200 external infrared sensor can be connected up via the data copy I/O connection (Western modular 8-pole). You can then also control the receiver from the other room.

Important	All figures in this manual refer to the on-screen display in German. How to
	select English as OSD language is described on pages 27 and 28.

9