Kathrein UFD 430 manual Safety instructions, Important notes regarding operation

Page 5

Safety instructions

The following section contains important information relating to operation, place of installation and connecting-up of the receiver.

Read these notes carefully before putting the unit into operation.

Important notes regarding operation

Extended absence / Thunderstorms

Always switch the unit off via its mains switch during periods of extended absence or at the onset of thunderstorms. This also applies to any other equipment attached

However, take account of any possible timer programming, and switch the unit on again in good time prior to the recording time.

Mains lead

Make certain that the mains lead (power supply lead) is undamaged. Never put the unit into operation if the mains lead is damaged.

Cleaning

Withdraw the mains plug before cleaning the unit. Use a dry cloth for cleaning.

Children-at-play

Pay attention that children do not insert objects into the ventilation slots. There is a risk of mortal danger due to electric shock.

Repairs

On no account remove the housing cover since there are dangerous voltages in- side the unit that may be contacted. The unit must only be opened by qualified specialists, so allow them to carry out any repairs or adjustments to your receiver. Unauthorised opening entails loss of guarantee.

The electrical safety of the unit can be affected by improper tampering with it

The manufacturer‘s liability excludes accidents occurring to the user when the unit is opened.

5

Image 5
Contents Kathrein Satellite Receiver UFD Contents Controls, displays and connections Rear panel controls and connections Remote control handset keysFront panel controls and displays Important notes regarding operation Safety instructionsImportant notes for siting and installation Connecting up the unit Connecting up and putting into operationSatellite signal connection Receiving system presetsUHF connection Inserting batteries into remote control handsetAudio connection Decoder connectionExternal infrared sensor Adjusting volume, balance and tone Switching the unit onReceiver operation Selecting a programmeSAT/TV changeover Muting the soundStereo- / Mono- / Channel changeover Making the settings Setting date and timeSaving settings and starting the clock Return to receive modeMaking settings Timer settingSaving settings Meaning of the columnsVideo recorder playback VCR Daily and weekly repeated switch-onDigital radio reception ADR Switching between TV and radio modeAnalogue radio programmes Programme category selection in ADR radio mode Search for ADR radio programmes Additional functions in ADR modeProgramme sorting inserting, swapping and copying Switching back to last programme swapDisplaying programme overview Operation without remote controlStop-watch Info menuProgramming TV programmes Tuning in TV programmesPolarisation/Oscillator Video menuDescription of menu entries Satellite frequency Decoder menu Orbit positionVideo deviation Programme name Audio operating modeAudio menu Audio carrier frequencyAudio de-emphasis for sound type Mono wide only Volume offsetSaving the settings Analogue radio menu Tuning in radio programmesProgramming radio programmes ADR radio menu Modulator output channel Initial settingsCalling the initial setup menu LNB supply voltage OSD languageLNB supply voltage in standby Programme selectionOscillator frequency LED brightnessADR search Changing the oscillator frequency DiSEqC menuSettings in the DiSEqC menu KHz signalTone-burst and DiSEqC-signal DiSEqC Tone burstDiSEqC Repeat UFO miniEeprom UFO microSwitching over remote control’s command set Features Specifications Connectors Scart connector pin designationsTemperature range AccessoriesConnection examples / Service note 935.2076/04.98/SKS/der Subject to alterations