Kathrein UFD 430 manual Connection examples / Service note

Page 38

Connection examples / Service note

The best picture quality is obtained if you connect the satellite receiver, TV set and video recorder by means of Scart cables.

A stereo TV set also allows you to receive the sound in stereo.

The Sat receiver can be connected to a TV set and video recorder and also a de- coder for Pay-TV programmes (e.g. Premiere) via Scart cables.

A hi-fi system is connected up for reception of analogue and digital (ADR) radio programmes.

In addition, a digital-audio-tape can be connected to the electrical SPDIF output of the receiver for reception of ADR radio programmes.

Connection of Sat receiver to TV set and video recorder with coaxial cables.

Note

Dear customer

 

In the unlikely event that you should experience problems with your receiver,

 

please contact your local specialist dealer.

38

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Kathrein Satellite Receiver UFD Contents Controls, displays and connections Rear panel controls and connections Remote control handset keysFront panel controls and displays Safety instructions Important notes regarding operationImportant notes for siting and installation Satellite signal connection Connecting up and putting into operationConnecting up the unit Receiving system presetsAudio connection Inserting batteries into remote control handsetUHF connection Decoder connectionExternal infrared sensor Receiver operation Switching the unit onAdjusting volume, balance and tone Selecting a programmeSAT/TV changeover Muting the soundStereo- / Mono- / Channel changeover Saving settings and starting the clock Setting date and timeMaking the settings Return to receive modeSaving settings Timer settingMaking settings Meaning of the columnsDaily and weekly repeated switch-on Video recorder playback VCRDigital radio reception ADR Switching between TV and radio modeAnalogue radio programmes Programme category selection in ADR radio mode Additional functions in ADR mode Search for ADR radio programmesSwitching back to last programme swap Programme sorting inserting, swapping and copyingStop-watch Operation without remote controlDisplaying programme overview Info menuTuning in TV programmes Programming TV programmesPolarisation/Oscillator Video menuDescription of menu entries Satellite frequency Decoder menu Orbit positionVideo deviation Audio menu Audio operating modeProgramme name Audio carrier frequencyAudio de-emphasis for sound type Mono wide only Volume offsetSaving the settings Analogue radio menu Tuning in radio programmesProgramming radio programmes ADR radio menu Modulator output channel Initial settingsCalling the initial setup menu LNB supply voltage in standby OSD languageLNB supply voltage Programme selectionOscillator frequency LED brightnessADR search DiSEqC menu Changing the oscillator frequencySettings in the DiSEqC menu KHz signalTone-burst and DiSEqC-signal DiSEqC Repeat Tone burstDiSEqC UFO miniUFO micro EepromSwitching over remote control’s command set Features Specifications Temperature range Scart connector pin designationsConnectors AccessoriesConnection examples / Service note 935.2076/04.98/SKS/der Subject to alterations
Top Page Image Contents