Kathrein UFD 430 manual Switching over remote control’s command set

Initial settings

Switching over remote control’s command set

The remote control handset contains two command sets. This allows two receivers to be operated independently in a room (not in conjunction with a twin receiver).

Note	Switchover is possible for remote controls that have 24 and 26 keys.
	For this purpose, programme one receiver on command set 1 and the second re-
	ceiver on command set 2.
	∙	Switch on receiver 1. Switch off receiver 2 using the mains switch							on the
		unit.
		⇒ Press the		key and keep it pressed.
	∙	⇒ Using the numeric keys			...	enter “901“.
		To adopt the code switch receiver 1 into standby using the						key, and then
		switch the receiver off using the mains switch					on the unit.
	∙ Set receiver 2 back into operation.
		⇒ Press the		key and keep it pressed.
	∙	⇒ Using the numeric keys			...	enter “902“.
		To adopt the code switch receiver 2 into standby using the						key, and then
		back into operation again. Set receiver 1 back into operation as well.
		⇒ Press the		key and keep it pressed.
Note		⇒ Using the numeric keys			...	enter “903“.
	With the first two settings the remote control must be pointer towards the respec-
	tive receiver which is switched on.
	With the		key you can now switch between the two command sets A and B (tog-
	gle function) and operate the two receivers in alternation.
	On delivery command set 1 is always active.
Note	If you are using only one receiver and the active command set has been switched
	over inadvertently due to maloperation rendering the receiver inoperable, the re-
	mote control can be switched back to command set 1 without difficulty. The proce-
	dure for this has already been described above.
Note	With remote control handsets that have 24 keys (remote controls of the 200-series
	receivers from Kathrein) code numbers 001, 002 and 003 are to be entered in
	place of codes 901, 902 and 903.

34