Kathrein MSK 125 manual RF Input Socket, USB Port, SD Card, Scart Output, Common Interface

Page 14

CONNECTIONS

RF INPUT SOCKET

Here the reception signal is delivered from the antenna system or cable network (coaxial F socket with BNC adapter).

The remote feeding voltage can be adjusted from 5 VDC to 20 VDC and can also be switched off. When the LNB voltage is switched on the right control LED illuminates green. If there is a short circuit of overload, this LED ﬂashes green. If there is an external voltage, the LED is red.

Please note that there is

•no voltage level higher than 120 dBµV,

•no peak voltage > 100 Volt

on the right RF input socket.

Failure to comply with these values can damage the input circuit!

USB PORT

Via the USB port (USB 1.1) inserted SD cards can be read.

SD CARD

The supplied SD memory card is used to store the measuring results. You can use SD cards of up to 1 GB max.

SCART OUTPUT

Via the scart socket on the front side of the MSK 125 the video and audio signals are

available for evaluation on an external monitor. The	button allows you to switch to
audio/video input.
Erroneous connection switching can damage the device!

COMMON INTERFACE

Slot for a common interface.

EAR PHONES SOCKET

Stereo 3.5 mm jack bush for connection of stereo ear phones

RS 232 INTERFACE

The RS 232 port allows you to perform a software update.

EXTERNAL DC POWER SUPPLY

The MSK 125 can be operated on the mains or by means of its integrated battery. The external voltage supply is provided by the supplied mains and charging unit via the DC socket on the left casing side of the MSK 125.

Use only the mains unit that came with the device.

14

Image 14

Contents MSK Validity of this Operating Manual General Safety InstructionsFOREWORD/IMPORTANT Instructions Contents FM Measurement Customer Service Storing Device SettingsMaintenance Features Technical Data Technical AppendixSafety Instructions Safety InstructionsMeaning of Symbols Product PackageFunctionality Function 8PSKTFT Colour Display Operating and Display ElementsLC Display LED DisplayTFT colour display Source selection Measurements LC displayInput block Alphanumeric input Overview of Keypad CommandsButton Operating and Display Elements Front View Fan Ear phones Loudspeakers Battery fuse DC supplyConnections Side ViewUSB Port External DC Power SupplyRF Input Socket SD CardGetting Started Switch on Switching OFF Setup MenuSetup Menu Settings Parameter Setting Mains and Battery OperationDefault Setup Settings AT Time of Shipment Mains OperationBattery Operation SAT SAT ANALOGUE/DVB-S2 SwitchCommand Overview of SAT Frequency Entry Analogue Satellite ReceptionLNB Voltage and 22 KHZ CHANGE-OVER Following voltages can be called up via button commandCommand overview for LNB voltage Button LNB voltageLevel overﬂow and underﬂow Sound Carrier Frequency SettingSAT Analogue Level Measurement Frequency in MHz Bandwidth Select Sound CarrierDigital SAT Reception Called up via button command Following voltages can be ButtonCommand overview for LNB voltage SAT DVB-S2 Level Measurement Setting DVB-S2 Demodulation ParametersDiseqctm Digital Satellite Equipment Control Command Overview for Diseqctm Button Hex codeSAT-CTRL menu DiSEqCTM menu Hex Byte Description Command Overview for Framing ByteCommand Overview for Address Byte Switch Read switching status ﬂag commited port Command Overview for Command ByteHex Command ID Description ByteCommand Overview for Data Byte Orbit Polarisation Switch Position Data Byte Low BandSimple DISEQCTM, Tone Burst List of Single Cable Diseqctm CommandCommand Overview for Simple Diseqctm Calling up DVB-S2 measurement DVB-S2 MER, BER and Offset MeasurementMpeg Image Representation in DVB-S2 Press to exit digital receptionCommand overview Locating SatellitesCommand overview for ﬁnding Finding Individual Reception FrequenciesTV Measurement Analogue CABLE/DVB C SwitchHF Standard Switch Analogue Cable Demod Menu Analogue TV Cable ReceptionFrequency Display and Entry Command Overview for TV Channel EntryChannel Display and Entry Command Overview for TV Frequency Entry Cable Analogue Level MeasurementLevel Overflow and Underflow Command Overview for Measure TV Audio Carrier FrequencyAudio Carrier Spacing and Level StandardSelect Soundcarrier Digital TV Cable Reception Channel Display and Entry Setting DVB-C Demodulation Parameters DVB-C/DVB-T/H MER, BER and Offset Measurement Level Measurement of DVB-C/DVB-T/H SignalsLC display for DVB-C signals To call up DVB-C/DVB-T/H measurementMpeg Image Representation in DVB-C HF Standard Switch Analogue TERRESTRIAL/DVB T/H SwitchHF Standard Switch Terrestrial Analogue Terrestrial TV ReceptionChannel Display and Entry Command Overview for TV Frequency Entry Select the required HF bandwidth by using the digit buttons Setting DVB-T/H Demodulation ParametersHF Standard Switch DVB-T Digital Terrestrial TV ReceptionChannel Display and Entry DVB-C/DVB-T/H MER, BER and Offset Measurement LC display for DVB-T signals Mpeg Image Representation in DVB-TFinding Individual Reception Frequencies Nicam Audio BIT Error Rate Measurement FM Measurement FM SwitchCommand Overview for FM Frequency Entry Level MeasurementCommand Overview for Find TV Spectrum Spectrum MeasurementSAT Spectrum Spectrum Measurement FM Spectrum Deleting Device Settings Storing Device SettingsStoring Device Settings TFT display LC displaySpectrum Memory Full Only 10 Spec. Possible Storing Measurement ResultsStoring Measurement Results in the Device Memory TFT displayDeleting Measurement Results from the Device Memory Storing Measurement Results on the SD CardStoring Measurement Results Data Logger Entering the Start Line for Automatic MeasuringStarting and Interrupting Automatic Measuring Entering the Stop Line for Automatic MeasuringStoring the Data Logger Measurement Results on the SD Card MessageMaintenance Customer Service Technical Customer SupportFeatures Technical Data RF componentLevel measuring component +14.1 dB SIGNAL-TO-NOISE RatioTechnical Appendix Command SET for EXR 20 Kathrein Matrix Diseqctm Commands for Kathrein MatricesCommand SET for Kathrein Matrices Command SET for EXR 22 Kathrein MatrixChannel Tables Channel UND Frequency TABLE, Standard B/G Frequency in MHZChannel UND Frequency TABLE, Standard L Frequency in MHZ VHF UHFChannel UND Frequency TABLE, D/K Standard Frequency in MHZ VIIChannel UND Frequency TABLE, I Standard Frequency in MHZ Oscillation frequency is made up as follows Calculation of SAT if Frequency Using the MSKThis is done as follows Hence the values for ARD Das Erste arePage Page 936.3474/A/0409/ZWT Technical data subject to change